Table of Contents
Advertisement
Navigation Device PNA-M4310
Once the car mount has been fixed in place you can insert
the navigation device into the adapter plate. The noses on
the adapter plate must fit into the corresponding holes of the
navigation device (see figure, arrow 3). Loosen the screws of
the car mount to change the navigation device position and
then tighten the screws in the chosen position (see figure,
arrows 4 and 5).
To loosen the navigation device from the car mount, press on
the latch on top of the adapter plate and remove the device.
To remove the car mount from the windshield, rotate the lock
again and then pull from the latch located at the bottom of
the suction pad (see figure, arrow 6).
Do not install the car mount (with or without the
!
navigation device) within the operating area of the
vehicle's airbag and install the car mount so that the
driver's view is not obstructed.
English
15
Advertisement
Table of Contents
