Philips HTS5520 User Manual page 18

Subwoofer
• Impedance: 4 ohm
• Speaker drivers: 165 mm (6.5") woofer
• Frequency response: 50 Hz-1.5 kHz
• Dimensions (WxHxD):
•
HTS5520: 122.6 x 307 x 369 (mm)
•
HTS5530: 196 x 392 x 342.2 (mm)
• Weight:
• HTS5520: 3.76 kg
• HTS5530: 6.3 kg
• Cable length: 4.3 m
Speakers
• System: full range satellite
• Speaker impedance: 4 ohm (center), 8 ohm
(Front/Rear)
• Speaker drivers: 2 x 3" full range
• Frequency response: 150 Hz-20 kHz
• Dimensions (WxHxD):
• Center: 280 x 95 x 92 (mm)
•
Front/Rear: 100 x 279.3 x 103 (mm)
• Weight:
•
Center: 1.4 kg
•
Front/Rear: 1 kg/each
• Cable length:
•
Center: 2 m
• Front: 4 m
• Rear: 10 m
Laser speciÀ cation
• Type: Semiconductor laser GaAIAs (CD)
• Wave length: 645 - 665 nm (DVD), 770 -
800 nm (CD)
• Output power: 6 mW (DVD), 7 mW
(VCD/CD)
• Beam divergence: 60 degrees.
16 EN
9 Troubleshooting
Warning
•
Risk of electric shock. Never remove the
casing of the product.
To keep the warranty valid, never try to repair the
product yourself.
If you have problems using this product, check the
following points before you request service. If you
still have a problem, register your product and get
support at www.philips.com/welcome.
If you contact Philips, you will be asked for the
model and serial number of your product. The
model number and serial number are on the back
or bottom of your product. Write the numbers
here:
Model No. __________________________
Serial No. ___________________________
Main unit
The buttons on this home theater do not work.
• Disconnect the home theater from the
power outlet for a few minutes, then
reconnect.
Picture
No picture.
• Ensure that the TV is switched to the
correct source for this home theater.
• If this happens when you change the TV
system, switch to its default mode: 1) Press
. 2) Press . 3) Press SUBTITLE.
No picture on HDMI connection.
• Check if the HDMI cable is faulty. Replace
with a new HDMI cable.
• If this happens when you change the HDMI
video resolution, switch to its default mode:
1) Press . 2) Press . 3) Press ZOOM.