Philips AZ127 Quick Start Manual

Always there to help you
Register your product and get support at
www.philips.com/support
AZ127
Question?
Contact
Philips

Quick start guide

This product has been manufactured by, and is sold under the responsibility
of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in
relation to this product.
Philips and the Philips Shield Emblem are registered trademarks of
Koninklijke Philips N.V. and are used under license.
AZ127_05_QSG_V7.0
AZ127_05_QSG_V7.0.indd 1
Always there to help you
Register your product and get support at
www.philips.com/support
Question?
Contact
Philips
Quick start guide
Before using your product, read all accompanying safety information.
* In CD/FM/AUDIO IN mode, press to power on the device.
* There is no message shown on the display panel in FM or TAPE mode.
* In CD mode, the device switches to standby mode automatically if there is no
playback for over 15 minutes.
AUDIO IN /
REPEAT SHUFFLE
PROG
6X1.5V R14/UM2/C CELL
AC~MAINS
To play with the device, you can use either alkaline battery (R14) or AC power.
REPEAT Play a track or all tracks repeatedly.
Turn on/off the unit.
Stop play or erase a program.
Pause or start play.
SHUFFLE Play tracks randomly.
PROG Program the play sequence of tracks.
Skip to the previous/next track or search within play.
Program tracks
1 In CD mode, press to stop playback.
2 PROG
Press to activate programming.
3 Press repeatedly to select a track, then press PROG to confirm.
4 Repeat steps 3 to program more tracks.
5 Press to play the programmed tracks.
6 To cancel the program, press twice.
ON OFF
DBB
AUDIO IN /
Pause.
Press to open the tape door.
Start to play.
Search within play.
Make sure that all the buttons are ejected when you close the tape
door with a tape inside.
2017/6/7 11:06:55