Panasonic Viera TX-P42X50E Operating Instructions Manual page 10

Indicator / Control panel
1 Function select
[Volume] / [Contrast] / [Brightness] / [Colour] /
[Sharpness] / [Tint] (NTSC signal) / [Bass] /
[Treble] / [Balance] / [Auto Setup] (p. 36, 37)
[Music] or [Speech] mode in the Sound Menu
2 Channel Up / Down, Value change (when using the
F button), Switching the TV on (press either button
for about 1 second when in Standby mode)
3 Changes the input mode
4 Mains power On / Off switch
Use to switch the mains power.
If you turned the TV off during Standby mode
by the remote control last time, the TV will be
in Standby mode when you turn the TV on with
Mains power On / Off switch.
When pressing the control panel button (1 - 4), the
control panel guide appears on the left side of the
screen for 3 seconds to highlight the pressed button.
5 Remote control signal receiver
Do not place any objects between the TV remote
control signal receiver and remote control.
6 C.A.T.S. (Contrast Automatic Tracking System)
sensor
Senses brightness to adjust picture quality when
[Eco Mode] in the Picture Menu is set to [On].
(p. 28)
Using the On Screen Displays
Many features available on this TV can be accessed via the On Screen Display menu.
Operation guide
Operation guide will help you to operate by using the
remote control.
Example: [Sound Menu]
Sound Menu
Mode
Bass
Treble
Balance
Headphone Volume
Surround
Auto Gain Control
Volume Correction
Speaker Distance to Wall
Select
EXIT
Change
RETURN
Operation guide
Auto power standby function
The TV will automatically go into Standby mode in the following conditions:
No signal is received and no operation is performed for 30 minutes in Analogue TV mode.
‡
[Off Timer] is active in the Setup Menu. (p. 17)
‡
No operation is performed for the period selected in [Auto Standby] (p. 35).
‡
This function does not affect the recording of Timer Programming and Direct TV Recording.
10
- Operation guide
1/2
Music
0
0
0
11
Off
Off
0
Over 30cm
Page up
Page down
5 6 7
7 Power and Timer LED
Red: Standby
Green: On
Orange: Timer Programming On
Orange (flash):
Recording of Timer Programming or Direct TV
Recording in progress
Red with orange flash:
Standby with Timer Programming On or Direct
TV Recording
The LED blinks when the TV receives a command
from the remote control.
How to use remote control
Open the main menu
Move the cursor / select the menu item (up and
down only) / adjust levels (left and right only) /
select from a range of options (left and right only)
Access the menu / store settings after adjustments
have been made or options have been set
Return to the previous menu
Exit the menu system and return to the normal
viewing screen
1
2
3
4
Rear side of the TV