Panasonic TX-P58V10E Operating Instructions Manual page 81

Problem
Sound is unusual
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
Cannot connect to the network
Cannot select the file during
DLNA operations
Cannot operate VIERA CAST
The TV does not switch On
The TV goes into
"Standby mode"
The remote control does not work
or is intermittent
An error message appears
●
Set the sound setting of the connected equipment to
"2ch L.PCM".
●
Check the "HDMI1 / 4 Input" setting in the Sound Menu. (p. 27)
●
If digital sound connection has a problem, select analogue sound
connection. (p. 77)
●
Check the HDMI cable is connected properly. (p. 70)
●
Turn the TV and equipment Off, then turn them On again.
●
Check an input signal from the equipment. (p. 78)
●
Use an equipment compliant with EIA/CEA-861/861B.
●
Check the LAN cable is connected properly. (p. 51)
●
Check the connections and settings. (p. 51 - 53)
●
Check the network equipment and network environment.
If the problem persists, consult your Internet Service Provider or
telecommunications company.
●
Is media server prepared? (p. 50)
●
Check applicable data format. (p. 50)
●
Check the connections and settings. (p. 51 - 53)
●
The server or connected line might be busy now.
●
Check the mains lead is plugged into the socket outlet.
●
Off Timer function is activated.
●
The TV enters "Standby mode" about 30 mins. after analogue
broadcasting ends.
●
Are the batteries installed correctly? (p. 8)
●
Has the TV been switched On?
●
The batteries may be running low. Replace them.
●
Point the remote control directly at the front of the TV (within a
30 degree angle of the front of the TV).
●
Situate the TV away from sunshine or other sources of bright light
not to shine on the TV's remote control signal receiver.
●
Follow the message's instructions.
●
If the problem persists, contact the authorized Service Centre.
Actions
81