Panasonic TH-37PV70FA Operating Instructions Manual page 40

Plasma television model no. th-37pv70fa; th-42pv70fa; th-50pv70fa
Table of Contents

Advertisement

FAQs
Chaotic image, noisy
No image can be
displayed
Blurry or distorted image
(no sound or low volume)
Unusual image is displayed
No sound is produced
Sound level is low
or sound is distorted
Sound is unusual
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
TV goes into
"Standby mode"
The remote control
does not work
An error message appears
40
Problem
Set "P-NR" in the Picture Menu (to remove noise). (p. 22)
Check nearby electrical products
(car, motorcycle, fl uorescent lamp).
Is "Colour" or "Contrast" in the Picture Menu set to the minimum?
(p. 22)
Check Colour system. (p. 25)
Reset channels. (p. 24)
Turn off the TV with Mains power On / Off switch, then turn it on
again.
Is "Sound mute" active? (p. 9)
Is the volume set to the minimum?
Sound signal reception may be deteriorated.
Set "MPX" (p. 22) in the Sound Menu to "Mono".
Check Sound system. (p. 25)
Set the sound setting of the connected equipment to
"2ch L.PCM".
Check the "HDMI1 Input" setting in the Sound Menu. (p. 22)
If digital sound connection has a problem, select analogue sound
connection. (p. 31)
Is the HDMI cable connected properly? (p. 34)
Turn Off the TV and equipment, then turn them On again.
Check an input signal from the equipment. (p. 38)
Use an equipment compliant with EIA/CEA-861/861B.
Off Timer function is activated.
The TV enters "Standby mode" about 30 min. after broadcasting
ends.
Are the batteries installed correctly? (p. 6)
Has the TV been switched On?
Follow the message's instructions.
If the problem persists, contact the authorized Service Centre.
Actions

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents