Charging The Appliance - Panasonic ES2065 Operating Instructions Manual

Using nail polish remover, benzine, alcohol, etc. to clean the appliance.
-
Leaving the appliance where it will be exposed to high temperatures or
-
direct sunlight.
Contact an authorized service center if the epilator or the cord get
•
damaged.
Before use
1. Remove the head while holding the head release button.
2. Push the head until it clicks.
Charging
1. Plug the charger into the epilator () and a
household outlet ().
2. Charge the appliance for approximately
1 hour. (Charging is completed when the
charging light blinks.)
The epilator can be used for
•
approximately 30 minutes after 1 hour
charge.
The charge light may not turn on after a few minutes in some cases.
•
However, it will turn on eventually if you continue charging.
The appliance can be left plugged in after it is fully charged without
•
deteriorating the battery life.
The recommended charge temperature is 15-35 °C (59-95 °F).
•
If you use the charger in temperature outside of the recommended range,
the following problems might occur.
The time it takes to charge the appliance increases. (approximately 3 hours)
-
The charger stops functioning.
-
If you use the charger in low temperature, the battery life might be
•
reduced.
The charger is intended to be correctly oriented in a vertical or fl oor mount
•
position.
If the shape of the plug does not fi t the power outlet, use an attachment
•
plug adaptor of the proper confi guration.
6
Changing the head

Charging the appliance

While charging: Red light appears.
•
After charging is completed:
•
Blinks once every second.
10 minutes after charging is completed:
•
Blinks once every 2 seconds.
Abnormal Charging: Blinks twice every second.
•

