Mitsubishi Electric CP9500DW-S Operation Manual page 3

CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his or her own
expense.
Operation is subject to the following two conditions;
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
WARNING:
In the USA or Canada, use the AC power cord according to the
recommendations as below, in order to comply with UL60950
and CAN/CSA C22.2 No. 60950-00.
Connect to the 120V receptacle of the room or the host equip-
ment.
The AC power cord should be UL or CSA approved and consist
of type SJT or SVT, size 16 or 18AWG, length 2.5m or shorter
cord with IEC320/C13 type, 125V 10A or higher rating connec-
tor and NEMA 5-15 type, 125V 10A or higher rating plug.
Use the AC power cord as specified above, so as not to
interfere with radio and television reception.
If you use other cables, it may cause interference with radio
and television reception.
WARNING:
In Europe, use the AC power cord according to the recommen-
dations as below, in order to comply with EN60950.
Connect to the 230V receptacle of the room or the host equip-
ment.
The AC power cord should be VDE approved and consist of
core size 1mm 2 or bigger, length 2.5m or shorter cord with
IEC320/C13 type, 250V 10A or higher rating connector and
CEE(7)VII type or IEC 320-2.2/E type, 250V 10A or higher
rating plug.
Use the AC power cord as specified above, so as not to
interfere with radio and television reception.
If you use other cables, it may cause interference with radio
and television reception.