Makita 9910 Instruction Manual page 6

more than 8mm
1
2
1. Steel plate
2. Adjusting screw
2
1. Dust spout
2. Dust bag
1
3
1. Optional hose 28 mm in inner
diameter
2. Hose of vacuum cleaner
3. Vacuum cleaner
6
003378
CAUTION:
• When installing the belt, make sure that the direction of the arrow on the
back of the belt corresponds to the one on the tool itself.
Adjusting belt tracking
004233
Switch on the tool and make sure that the belt is aligned properly. If the edge
of the belt extends beyond the edge of the steel plate or the edge of the belt
retracts more than 8 mm away from the edge of the steel plate, use the adjust-
ing screw to adjust the belt tracking.
Dust bag
003387
Attach the dust bag onto the dust spout. The dust spout is tapered. When
1
attaching the dust bag, push it onto the dust spout firmly as far as it will go to
prevent it from coming off during operation.
When the dust bag is about half full, remove the dust bag from the tool and pull
the fastener out. Empty the dust bag of its contents, tapping it lightly so as to
remove particles adhering to the insides which might hamper further collec-
tion.
NOTE:
• If you connect a Makita vacuum cleaner to this tool, more efficient and
cleaner operations can be performed.
Connecting to Makita vacuum cleaner
004050
Cleaner sanding operations can be performed by connecting the belt sander to
2
Makita vacuum cleaner.
When connecting to Makita vacuum cleaner, an optional hose 28 mm in inner
diameter is necessary.