Minox DC 8022WP User Manual page 7

Hide thumbs Also See for DC 8022WP:
Table of Contents

Advertisement

2. The camera should be soaked and rinsed in a bucket of fresh water for a few
minutes. Do not soak the camera for too long or pour water over the camera
directly from the water faucet.
3. Make sure to use only clean, fresh water to rinse the camera. Do not use any
cleaning agent. This may cause damage to the camera.
4. Use a piece of clean, dry cloth to wipe off remaining water or sand.
5. Make sure the camera is completely clean and dry before opening the battery/
memory card cover.
6. If you need to change the battery or memory card after using the camera
underwater, make sure the camera is completely clean and dry. Open the battery/
memory card cover with the battery compartment facing downward. Wipe off
remaining water along the battery/memory card cover to prevent moisture inside.
Storage and Maintenance
1. Do not use chemicals for cleaning, rust prevention, or repairing. This may cause
failure of the camera's waterproof function.
2. If the surface of the camera has been damaged (ex. damage on the lens, LCD
monitor, or other cuts or cracks), do not use the camera underwater. Please
contact your local retailer or service center for repair.
3. Store camera at room temperature in a clean and dry area. Never store camera in
a dark, damp area or in direct sunlight.
4. Do not expose the camera to direct sunlight for prolonged periods.
5. When storing the camera, prevent the battery compartment from a build up of
moisture.
6. Before storing the camera, remove the battery and memory card and keep in a
clean, dry area. Make sure the camera and its accessories are clean and dry
before storage.
Other Important Information
1. The waterproof function does not apply to the camera's accessories (ex. battery
and memory card).
2. If the camera is subjected to substantial shocks, the camera might be damaged or
its waterproof function might fail.
3. If the camera has been used in underwater. It should be rinsed in fresh water as
soon as possible.
4. Water, sand or dirt inside the camera may cause failure of the camera.
5. Avoid getting sunscreen or suntan oil on the camera as it may cause discoloration
of the surface. If any oil gets on the camera, wash it off immediately with warm
water.
EN-7

Advertisement

Table of Contents
loading

Table of Contents