Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Doro R52
Summary of Contents for Doro R52
- Page 1 Manual doro R52...
-
Page 2: Buttons
1 Two-way recording/Memo 5 Stop / On/Off 2 Delete message 6 Set Clock/Skip Message 3 Repeat/OGM record 7 Volume Control 4 Play/Pause... -
Page 3: Installation
OFF position no calls will be answered and the display will be off. Please note! Although turned Off, the Answering Machine will answer a call after 16 Rings. This is to allow the remote ON and other features to be accessed. www.doro.com... -
Page 4: Operation
4. Press repeatedly until the correct minute/s are announced. 5. Upon completion release the button. 6. The selected settings will now be announced. Checking Current Day/Time Press . To hear the current settings, e.g.: Thursday, five fifty PM. www.doro.com... -
Page 5: Number Of Rings
If the machine answers after two rings new messages have been recorded. Voice Control (VOX) The answering machine will record a message as long as the caller keeps speaking (max. time user selectable 60/300 seconds). If the caller stops speaking, the answering machine will disconnect after approximately 7 seconds. www.doro.com... -
Page 6: Outgoing Message
. The current outgoing message will now be played. Please note! In case of a power failure if no back-up battery is fitted your outgoing message will be erased. The answering machine will then use the pre-recorded outgoing message. www.doro.com... -
Page 7: Playback Of Messages
If you want to delete a single incoming message press C while the message is playing. To erase all messages after playback, press and hold C until unit beeps. Please note that new messages cannot be deleted until they have been played. www.doro.com... -
Page 8: Call Monitoring
Once the code is accepted, several remote control commands are available (please see next page). Remote Code This three-digit remote code is required in order to gain access to the remote functions of the answering machine. The remote code is printed underneath the machine. www.doro.com... -
Page 9: Room Monitoring
If you do not enter any remote control command, the answering machine will disconnect after a few seconds. If you listen to any incoming messages for more than 2 minutes and 40 seconds, you will hear a tone. Press any key to continue. www.doro.com... -
Page 10: Remote Activation
-- ......... Indicates OGM not recorded or day/time not set ........Indicates battery is low ........Memory full ........Announcement/Record playback ........Memo recording ........2-way recording ........No message but announcement recorded ......... Pause in playback mode No display ......Answer off. www.doro.com... -
Page 11: Troubleshooting
I hear a tone sequence, but nothing happens when I press the playback button: There are no incoming messages. If the answering machine still does not work, refer to page 12. www.doro.com... -
Page 12: Australia And New Zealand
(As a matter of precaution, we recommend disconnecting the telephone during a thunderstorm). This guarantee does not affect your statutory rights. www.doro.com... - Page 13 English Other AUSTRALIA NEW ZEALAND DORO Australia Pty Ltd Atlas Gentech (NZ) Limited PO Box 6760 Private Bag 14927 Baulkham Hills BC NSW 2153 Panmure Australia Auckland New Zealand Consumer Support Consumer Support Ph: 1300 885 023 Ph: 0900-500-25 (Toll Call)
- Page 16 Australia(English) Version 1.0...
Need help?
Do you have a question about the R52 and is the answer not in the manual?
Questions and answers