Miele Integrated slimline dishwasher Installation Instructions Manual page 13

The dishwasher must be installed so
that the water and electricity supplies
can be accessed through an adjacent
cabinet. The supplies must not be
located behind the machine.
The floor of the cut out where the dish-
washer will be installed should be even
in height with the surrounding kitchen
floor. Plywood can be secured to the
floor to make the two areas even.
^ Make a 2" x 4" (5 x 10 cm) cut out in
the side or bottom of the cabinet ad-
joining the dishwasher. This cut out is
necessary for connections to pass
through.
^ Make certain that there are no rough
edges that could damage the power
cord or hoses. If metal cabinets are
used, place the supplied rubber
grommet around the edge of the ope-
ning before passing the cable
through.
^ Slide the machine into the opening,
making sure the electrical cable and
hoses can reach their connection
points without kinking.
The left side of the optic indicator
reflector and the optic indicator must
align.
The drain hose connection at the rear of
the dishwasher can be turned to allow
the hose to be angled to the right or
left.
^ Exercise care when sliding the dish-
washer in or out, to prevent damage
to the power cord or hoses.
13