For Your Guidance; Specifications - Panasonic QuintrixF TX-28PK20D Operating Instructions Manual

FOR YOUR GUIDANCE

H Service
Before requesting service, please refer to the troubleshooting
guide on previous page to determine the symptoms. To obtain
service please contact your local Panasonic dealer quoting the
model number and serial number (both are located at the rear of
the TV).
H TV Games / Home Computers
Extended use of TV games or home computers with any television
set can cause a permanent 'shadow' on the screen. This type of
irreversible picture tube damage, can be limited by observing the
following points:
D Reduce the brightness and contrast levels to a minimum
viewing level.
D Do not operate the television set for a continuous period of
time while using TV games or home computers.
D This type of picture tube damage, is not an operating
defect, and as such is not covered by the Panasonic
warranty.

SPECIFICATIONS

Power Source
Power Consumption
Standby Consumption
Picture Tube
Visible Diagonal
Audio Output
Music Power
Dimensions
Weight
Receiving
Systems/ Systems/
Band name
Number of programme
positions
Aerial - - Rear
Headphones - - Front
AV - - Rear
AV - - Front
Specifications are subject to change without notice. Weight and dimensions shown are approximate.
30
H
W
D
PAL B/G, H, SECAM B/G
VHF E2 -- E12
VHF A -- H (ITALY)
CATV (S01 -- S05)
CATV S11 -- S20 (U1 -- U10)
PAL D/K SECAM D/K PAL D/K, SECAM D/K
VHF R1 -- R2
VHF R6 -- R12
PAL 525/60 Playback of NTSC tape from some PAL video recorders (VCR)
M.NTSC (AV input only) Playback from NTSC 4,43 MHz Videorecorders (VCR)
NTSC (AV input only) Playback from NTSC Videorecorders (VCR)
AV1 -- 21 pin terminal -- Audio / Video in / out, RGB in.
AV2 -- 21 pin terminal -- Audio / Video in/out, S--Video in, Q--Link
AV3 - - S ---Video in, 2 x RCA Audio in, 1 x RCA Video in.
H Last Position Memory
Certain functions have a last position memory, i.e. the setting at
the time of switch--off will be the setting used when the receiver is
switched on again:--
Programme
OSD language
AV Position
Volume
MPX
Bass
Treble
Balance
Colour Balance
Status
P--NR
Volume correction
Decoder (AV2)
Flicker reduction
H Sleep Feature
If the set is not switched off when the TV station stops transmitting ,
it will automatically go to standby mode after 30 minutes. This
function will not operate when the TV is in AV mode.
TX- -28PK20D
220 -- 240V 50Hz A.C.
173W
1,4W
66 cm
2 x 7W RMS (2 x 15W MPO), 8Ω impedance
497 mm
718 mm
523 mm
42 kg
VHF H1 -- H2 (ITALY)
UHF E21 -- E69
CATV S1 -- S10 (M1 -- M10)
CATV S21 -- S41 (Hyperband)
VHF R3 -- R5
UHF E21 -- E69
99 + VCR
UHF / VHF
3,5mm, 8Ω impedance
2 x RCA Audio Monitor Out.
Tint
(M.NTSC / NTSC only)
Contrast
Sharpness
Aspect
Standby
Artificial Intelligence (AI) --- Picture
Colour
Brightness
Ambience
Teletext mode
Q--Link
Geomagnetic correction