Advertisement
Quick Links
Advertisement
Related Manuals for Hans Grohe Metris 31100XX1
Summary of Contents for Hans Grohe Metris 31100XX1
- Page 1 Installation Instructions / Warranty Metris 31100XX1 Metris 31101XX1...
-
Page 2: Technical Data
Metris Electronic Lavatory Faucet with Temperature Control 31100XX1 Metris Electronic Lavatory Faucet 31101XX1 Technical Data Max. water pressure Recommended pressure Max. hot water temp. Recommended hot water temp. Flow rate Automatic shutoff Hole size in mounting surface Max. mounting surface thickness •... -
Page 3: Installation
Installation Flush the hot and cold supplies thoroughly before install- ing this faucet. Place the faucet in the hole on the mounting surface (1). Tighten the mounting nut (). Install the adapters and filters on the stops (3). Install the supply lines (4). Be careful not to twist the supply lines, or they may become loose from the faucet, causing a leak. - Page 4 Turn the water on to the faucet (1). Peel the protective film from the sensor (). Wait 15 seconds, the place a hand in front of the sensor (3). The water should turn on automatically. Model 31100 only: Pivot the temperature control lever forward to make the water cooler (4).
- Page 5 Cleaning: Block the sensor for 5 seconds (1). This will turn the water off for approximately 90 seconds, so that the sink may be cleaned (). Faucet Maintenance Replace the battery When the battery is low, the sensor will flash. Remove the set screw from the back of the faucet (1).
- Page 6 Reset the faucet: Remove the set screw with a .5 mm Allen wrench. Block the sensor for seconds. Wait 10 seconds (1), then replace the set screw (). Wait 15 seconds (3). Place a hand in front of the sensor (4).
- Page 7 Clean the filters and aerator If the flow of water is reduced, the aerator and/or the filters must be cleaned. To clean the aerator: Block the sensor for 5 seconds to temporarily shut off the water (1). Unscrew and remove the vandal resistant aerator using the enclosed key ().
-
Page 8: Replacement Parts
Replacement Parts aerator solenoid valve fixation set connection hose check valve electronics battery Important note: the check valves should be removed and inspected yearly. 9861000 96904000 9781000 98809000 96456000 96905000 97399000... - Page 9 Cleaning Recommendation for Hansgrohe Products Modern lavatory faucets, kitchen faucets, and showers consist of very different materials to comply with the needs of the market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain criteria when cleaning.
-
Page 10: Limited Lifetime Consumer Warranty
Limited Lifetime Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada. - Page 11 Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclu- sion may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from State to State.
- Page 12 Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004 Tel. 770 360-9880 • Fax 770 360 9887 www.hansgrohe-USA.com...