LENCO MES-216 User Manual page 9

Connecting to monitor
IMPORTANT: The slave unit will only work with the main unit by using the car
adaptor. It will NOT work when you use the AC adaptor.
1. Monitor Unit
FRONT VIEW
1. STANDBY button - Press it to set the unit in
standby mode, press it again to enter work
mode.
2. MENU button - Press it to enter initial
settings menu. Press it again to move up or
down to select different OSD item.
3. REMOTE CONTROL SENSOR
4. LEFT button - Press it to move left to reduce
the level of different OSD item in OSD menu
mode.
5. RIGHT button - Press it to move right to
adjust the level of different OSD item higher in
OSD menu mode..
6. EXIT button - Press it to exit the menu.
7. BUILT-IN SPEAKER
8. TFT Display
SIDE VIEW
9. POWER SWITCH
10.12V DC IN JACK
11. AV IN JACK - Connect DVD or other external
AV equipment to this jack to use the monitor.
12. PHONE JACK - Connect headphone to this
jack for private listening.
13. VOLUME - Rotate this knob to adjust the
volume lower or louder.
14. POWER INDICATOR / STANDBY INDICATOR - It is green in working mode, it is red in standby
mode.
BACK VIEW
15. Stand Holder - Pull the back bracket out, you can support and place the player levelly on the stage.
8