Panasonic Viera TH-42PZ700E Operating Instructions Manual page 28

Tuning Channels
Set DVB
channel
manually
DVB Manual
Tuning
Set Analogue
channel
manually
Analogue
Manual Tuning
Add
DVB channel
automatically
Add New
DVB Services
Display a
notifi cation
message
New Service
Message
Check
DVB signal
DVB Signal
Condition
28
Normally use "Auto Setup" or "Add New DVB Services" for the DVB channel setting.
If tuning has not done completely, use this function.
DVB Manual Tuning
Frequency [CH21]
Signal Quality 0
Signal Strength 0
Prog. Channel Service Name Net ID.
Stopped
■
Fine Tuning
Use to make small adjustments to the tuning of an individual channel (affected by weather
conditions, etc.)
■
Manual Tuning
Set Analogue channel manually after Auto Setup.
If a VCR is connected with only the RF cable, select programme position "0".
Analogue Manual Tuning
Programme 1
Fine Tuning
Manual Tuning 2 78 1
Select the programme position
Any new services found will be added to the DVB Service List (p. 25) automatically.
Add New DVB Services
Please wait! 5
Prog. Channel Service Name Net ID.
ZDF
ARD
This will take about 3 mins.
Selects whether to give a notifi cation message when a new DVB service is found. (Off / On)
New DVB service found!
Press OK to add new service.
Press EXIT to lgnore.
Selects a channel and checks the DVB signal condition.
Use for adjusting the direction of the aerial.
•
To change the programme during the menu appears
DVB Signal Condition
DVB Programme
[70] CBBC Channel
Signal Quality
Off
Signal Strength
0 5 10
select channel
474,00 MHz adjust frequency
10
( set where the level of "Signal Quality"
10
TS ID. Quality
becomes the maximum)
search
•
All services found will be added to the
DVB Service List (p. 25) automatically.
[CH33]
41
Select the channel
•
The new service is added with the current settings
saved as they are.
69
TS ID. Quality
Search and store
Signal Quality:
•
Green bar Good
•
Yellow bar Poor
•
Red bar Bad (Check the aerial)
search
store