Error Message; Maintenance - Panasonic MW-10 Operating Instructions Manual

Troubleshooting guide
Remote control
Cannot operate the remote
control.
Another device does not operate
properly when using the remote
control of this unit.
The unit does not operate
properly when using the remote
control of another device.

Error message

No card.
This card cannot be played.
This card cannot be read.
The write protection switch of the
SD card is set to "LOCK."
No disc.
This disc cannot be played.
This disc cannot be read.
No compatible device is
connected.
A communication error occurred.
No photo fi les.
This photo cannot be played.
Playback cannot continue
because there was a photo fi le
error.
The clock and calendar cannot be
used because the time has not
been set.
Timer audio playback could not be
started.
Set the mode on your remote
control to "Mode 1" (or "Mode 2").

Maintenance

Unplug the AC mains lead from the household mains socket and wipe it using a soft and dry cloth.
• When the dirt is heavy, wring water out of a wet cloth to wipe the dirt and then wipe with a dry cloth.
• Do not use solvents including benzine, thinner, alcohol, kitchen detergent, etc. This might cause the exterior case to be
deformed or the coating to come off.
• Before using chemically treated cloth, read the instructions that come with the cloth carefully.
22
Insert (+, –) of battery correctly. ( P7)
Replace with the new battery. ( P7)
If the remote control mode on the main unit does not match the one on the remote
control, match the mode of the remote control to the one of the main unit. ( P18)
If the display is opened, close it.
Change the remote control mode of this unit so another device does not interfere with
this unit's operation. ( P18)
The SD card is not inserted.
Insert the SD card.
This SD card cannot be played on this unit.
Insert the playable SD card. ( P5)
The SD card is write-protected.
Cancel the write protection switch. ( P4)
The CD is not inserted.
This CD cannot be played on this unit.
Insert the playable CD.
The iPod is not connected.
Connect the iPod correctly. ( P11)
The iPod incompatible with this unit is connected.
Use the iPod compatible with this unit. ( P5)
The iPod is not connected.
Connect the iPod correctly. ( P11)
There are no photo fi les on the selected media.
Select the media containing photos. ( P14)
This photo cannot be played on this unit.
Abnormality occurred during the playback of photo fi les.
Remove the media once and check if the photo fi les are compatible with this unit
( P5). Then, insert the media again.
To use the clock/calendar, clock setting is necessary.
Press [e, r] to select "Set time" and set clock. ( P9)
Timer cannot start on this screen.
Restore the standard screen before the start time of the timer.
The remote control mode settings do not match the main unit settings.
Press the displayed numbered button and [OK] for more than 2 seconds and switch the
remote control mode of the remote control.