Recording; Setting The Time - Panasonic RX-D27 Operating Instructions Manual

You can record radio broadcasts or CDs.
Before recording
• This unit is suitable for recording normal tapes, but it cannot record
onto high and metal position tapes to their full potential and prior
recordings will not be erased correctly.
• The recording level is set automatically.
• Take up the leader tape before proceeding.
Leader tape (Recording cannot be made.)
1 3
1 Press [ / STOP/EJECT ] to
open the deck and load a cassette.
Close deck by hand.
Side to be recorded
facing you
2 Select the source to be recorded.
When recording radio broadcasts
Tune in the station. (Perform steps 1–3 of "Normal tuning" on page 6.)
When recording CDs
Insert the CD to be recorded.
(Perform steps 1 and 2 of "Normal play" on page 7.)
Press [CD / ] and then [
If you want to record programmed tracks, program desired tracks
before proceeding to step 3.
Press [ ] to start recording.
3
[ PLAY ] is also depressed with [
Recording starts (one side only).
The CD also starts playing if in CD mode.
1
This is a 24-hour clock.
1 Press [TUNER/BAND –AUTO PRESET] to turn the unit on.
You can also use [CD / ], [
Remote control only
2 Press [CLOCK/TIMER ADJ] once.

Recording

Exposed tape facing
upward
] to switch to CD mode.
].

Setting the time

2 · 4
3
PLAY] to turn the unit on.
To stop recording
Press [ / STOP/EJECT ]. (The CD does not stop.)
To stop recording temporarily
Press [ PAUSE ]. (The CD does not stop.)
Press once again to resume recording.
To record on the other side of the cassette
Turn the cassette over and press [
If the CD finishes before the cassette
Recording continues. Press [
If the cassette finishes before the CD
The CD continues playing. Press [
Erase protection
Use a screwdriver or similar object
to break out the tab.
To re-record on a protected cassette
Cover the hole with adhesive tape.
To erase a tape
1. Press [TAPE/OFF].
2. Insert the cassette with the side to be erased facing towards you and
the exposed tape facing up.
3. Press [ ].
[ PLAY ] is depressed at the same time.
Note
• Noise may be recorded if this unit is near a TV. Keep the units at least
1.5 meters apart.
• Changes to volume and sound quality do not affect recording.
• To prevent interruptions to recording, make sure there is constant AC
power supply to the unit or replace the batteries.
• While recording you cannot perform the following operations.
-Switching play of the source (CD, Radio, Tape)
-Switching the radio AM/FM frequency
-CD skipping, searching
Your attention is drawn to the fact that recording pre-recorded tapes or
discs or other published or broadcast material may infringe copyright laws.
3 Within 10 seconds
Press [– / ] or [ / +] to set the
time.
Press and hold to change the time faster.
Remote control only
4 Press [CLOCK/TIMER ADJ].
To switch to clock display
Press [DISPLAY].
Clock display Current display
Displaying the clock temporarily
Press [CLOCK/TIMER ADJ].
The clock is shown for about 10 seconds.
Note
The clock is accurate to within
Readjust if necessary.
].
/ STOP/EJECT ] to stop it.
] to stop it.
Side A
Tab for Side A
Tab for Side B
Adhesive tape
60 seconds a month.
9
RQTT0627