Connections; Tuning The Tv To Your Vcr (Line Recording) - Panasonic NV-FJ80AM Operating Instructions Manual

Connections

A: Basic Connections
(1)
(2)
A-2
CH ADJ.
B.G.H
RF SELECT
D.K.K1
A-3
(1) TV Set (Not Supplied)
(2) Aerial Connector
(3) Aerial (Not Supplied)

Tuning the TV to your VCR (Line Recording)

It is possible to view the video picture on your TV
in the same way that you watch TV broadcasts.
If you have connected the VCR (Line
Recording) to the TV through the Audio/Video
Input Sockets, then you do not need to follow
the procedure below.
Operations
1 Turn on the TV and
VCR (Line Recording).
2 Insert a recorded video
cassette tape.
• To start playback, see
page 6.
3 Select the TV channel on
which the playback picture is
viewed.
• UHF channel E38
4 Stop playback.
4
(3)
A-1
VIDEO
RF OUT
L
AUDIO
R
RF IN
IN OUT
POWER Í/ I
STOP
B: Connection to a TV using the
Audio/Video Input Socket
CH ADJ.
B.G.H
RF SELECT
D.K.K1
(5)
B-2
(1) TV Set (Not Supplied)
(2) VIDEO IN
(3) AUDIO IN
(4) AV Cable (Supplied)
(5) Audio Cable (Not Supplied)
(6) Stereo Amplifier (Not Supplied)
The playback picture is transmitted on channel
E38 of the broadcasting channels. If you are
encountering interference from another
broadcast on the video channel, you may
readjust to a free channel by using [CH ADJ.]
screw. Note that if [CH ADJ.] screw is used, then
you will have to re-tune your TV to the playback
picture following steps 2–4.
RF SELECT
Use [RF SELECT] to select the colour TV system
used by the TV to be connected.
B.G.H: PAL B.G.H./SECAM B.G.
D.K.K1: PAL D/SECAM D.K.K1
POWER Í/I Button
Press to switch the VCR (Line Recording) from
on to the standby mode or vice versa. In the
standby mode, the VCR (Line Recording) is still
connected to the mains. When the VCR (Line
Recording) is turned off, the [STANDBY]
indicator (on the front panel) is lit. When the VCR
(Line Recording) is turned on, the [120] indicator
(on the front panel) is lit.
(1)
(2)
B-1
VIDEO (4)
RF OUT
L
AUDIO
(5)
R
RF IN
IN OUT
(6)
(3)