Manual Clock Set - Panasonic PVQ-1312W Operating Instructions Manual

dy to Play)

Manual Clock Set

If AUTO CLOCK SET was incomplete, manually
set the clock as follows.
1
Press ACTION on the Remote to
display SET CLOCK Menu screen.
SET CLOCK
1 / /
DST : ON
SELE CT MONTH
SELECT :
SET :
END : ACT I ON
2
Press to select the month
and press to set. In the same
manner, select and set the date,
year, time, and DST. (Daylight
Saving Time)
SET CLOCK
2 / 6/ 2 / 6/ 2002 WED 2002 WED 12 12 00 00PM PM
SELE CT COMPLETED SE COMPLETED
SET :
END : ACT I ON
3
Press ACTION twice to start
CLOCK and exit.
POWER
ACTION
9
Reset all unit Memory Functions
When moving unit to a new location, or if a
mistake was made in the Initial Setup section.
• Make sure a tape is not inserted in the unit.
<Model PVQ-2012 unit shown>
:
1 Turn the unit
Power on.
2 Press and hold both PLAY and
FF on the unit for more than 5
seconds.
• The power will shut off.
:
• Please ignore "NO CASSETTE" warning.
DST : ON
3
Do "Initial Setup" on page 8.
SELECT/SET
Note to CABLE System Installer
:CH UP
This reminder is provided to call the
:CH DOWN
CABLE (Cable TV) System Installers
:VOL UP
attention to Article 820-40 of the NEC
:VOL DOWN
that provides guidelines for proper
grounding and, in particular, specifies
that the cable ground shall be con-
nected to the grounding system of the
building, as close to the point of cable
entry as practical.
POWER POWER VOL VOL CH CH STOP/EJECT REW/ STOP/EJECT REW/ PLAY/REPEAT FF/ PLAY/REPEAT FF/ REC TIMER/FM REC TIMER/FM
REC ON TIMER REC ON TIMER PROG TIMER PROG TIMER
VIDEO IN VIDEO IN AUDIO IN AUDIO IN
ACTION ACTION
9