Advertisement
Front panel
Rear panel
14
RQT6019
Names of the parts
(
) Channel fader (INPUT)
(
) Input selector (LINE, PHONO)
(
) LOW-range level control (LOW)
MIC volume level control (MIC)
AUX/EFFECTOR volume level control (AUX/EFFECTOR)
MASTER volume level control (MASTER)
(
) Input sensitivity control (TRIM)
(
) HIGH-range level control (HIGH)
OUTPUT LEVEL meter (OUTPUT LEVEL)
This indicates the [LINE OUT] (L and R channels) and [MONI-
TOR OUT] output levels.
MONITOR volume level control (MONITOR LEVEL)
MONITOR BALANCE control (MONITOR BALANCE)
This adjusts the balance between the [LINE OUT] source and
source selected by the [MONITOR CUE] selector.
MONITOR source selector (MONITOR CUE)
Channels
and
can be selected as the output for headphones
or monitor speakers regardless of the position of the faders.
CROSS FADER (CROSS FADER)
This enables the balance between CH
justed.
Power button (POWER)
Headphones jack (PHONES)
MIC input jack (MIC)
CROSS FADER switch (CROSS FADER)
You can reverse the input balance of CH
trolled with the cross fader
NORMAL: output as labeled
REVERSE: output reversed
Front panel
Rear panel
Power input socket (AC IN
(
) LINE IN connector (LINE IN)
(
) PHONO IN connector (PHONO IN)
LINE OUT connector (LINE OUT)
REC OUT connector (REC OUT)
AUX IN connector (AUX IN)
PHONO grounding terminal (PHONO)
Secure the grounding wire of the turntable to [PHONO] to pre-
vent hum and noise.
MONITOR OUT connector (MONITOR OUT)
Outputs the same signal as the headphones. Connect a monitor
amplifier when monitoring from the speakers without headphones
as in independent DJ booths. Connect the general output ampli-
fier to [LINE OUT]
.
[MONITOR BALANCE] control
Select [CUE] (completely to the right)
•Works as past general DJ mixer monitors.
•Allows the CH (
,
) input selected with [MONITOR CUE]
be monitored regardless of the position of the [INPUT] channel fad-
ers and [CROSS FADER].
Select [MASTER] (completely to the left)
•Disregards the source selected with [MONITOR CUE] (
•Allows monitoring of the output from the [LINE OUT] connector
Select the center
•Allows the CH (
,
) input selected with the [MONITOR CUE]
control
and the output from the [LINE OUT] connector
mixed and monitored.
Note:
The channel faders are disigned for a long service life, but this
can be shortened if they are used in a situation that requires
rapid movement, such as during Hip-Hop transfer play. The con-
trols may need to be replaced frequently if used this way.
A spare channel fader is provided inside the bottom panel of
the unit. Refer to the additional instructions.
Consult your dealer if the cross fader ever needs replacing.
Fader replacement
Use numbers indicated in parentheses when asking for replace-
ment parts.
•Channel fader (RFKVHDX1200B)
and CH
to be ad-
and CH
con-
.
)
,
).
to be
to
.
Hide quick links:
Advertisement
Chapters
