Exchanging Batteries; Connecting The Dvd Player To A Television; Connection To A Television With Scart Cable/Rgb; Connection To A Television Via S-Video - EBENCH KH 6777 Operating Instructions Manual

.. Exchanging batteries
The batteries must be exchanged when remote controlled
operation of the DVD Player is disrupted or does not func-
tion at all.
Always exchange both batteries together to re-establish
full power.
Please note:
Spent batteries must not be disposed of in the do-
mestic waste. Hand in spent batteries at collecting
or special waste-disposal points, or return them to
the place where they were purchased.
If you eventually have to dispose of the remote control
of the DVD Player, then ensure that the batteries are
removed beforehand!

7. Connecting the DVD Player to a television

After having set up the DVD Player it can then be connected
to a television. The DVD Player can be connected to televi-
sions with the PAL, NTSC and SECAM television standards.
To connect the DVD Player to a television with ...
• NTSC standard, then the video settings in the so-called
"OSD" menu of the DVD Player must be changed because
this is where PAL has been works adjusted as television
standard.
• Settings do not have to be changed to use the SECAM
standard. The works adjusted settings for the PAL standard
also enable DVD Player operation with SECAM televisions
provided that they can also process PAL signals.
➧ For this subject please also refer to Chapter 11.3 "Video
Settings: Setting Video Output "
There are different ways to connect the DVD Player, depend-
ing upon the configuration of the given television:
.. Connection to a television with SCART
cable/RGB
Please note:
The best connection in terms of quality is when the
DVD Player is connected to a television with a SCART
cable via the RGB input. Select this connection if the
television features an RGB connection. Check the
operating instructions for the given television if
you are not sure whether or not the television has
an RGB input.
 KH 6777
IB_KH6777_EN 10
Proceed as follows to connect the DVD Player to a televi-
sion with a SCART cable ...
1 Insert the plug of the supplied SCART cable in the "EURO
SCART" inscribed socket at the back of the DVD Player.
2
Insert the plug on the other end of the SCART cable in
the television's SCART socket.
3
Set the television in the AV channel to RGB mode. Refer
to the operating instructions of the given television if
you are not sure how to set this.
➧ For this subject please also refer to Chapter 11.3."Video
Settings: Setting Video Output".
.. Connection to a television via S-Video
Please note:
For this manner of connection the television must
have an S-Video input and two unassigned chinch
sockets.
If you are not sure whether or not the television is
S-Video capable or has chinch sockets, then please
refer to the operating instructions for the given tel-
evision.
To connect the DVD Player to the television via S-Video ...
23.09.2003, 0:56 Uhr
2
1