Advertisement
Assembly Instructions for SAT2 Speaker Stand
Parts List
a - Base. (2)
e - Steel isolation
spikes and adjustment
nut. (6)
f - Clamping
mechanism. (2)
i - Foam dampening
i - Foam dampening
pad. (4)
n - Double sided adhesive pads (8)
k - 5mm screw mounts
bracket and clamp mechanism
to inner post. (2)
l - M4 Base to post screw. (4)
Speaker to
bracket mounting
screws
1/4-20
5mm
STEP 1 – Prepare the stand base.
Place speaker stand base (a) upside down on ground. Locate steel
isolation spikes and adjustment nuts (e). Thread adjustment nuts
approximately half way onto the spikes, and then thread spikes into
three holes on the stand base, until adjustment nuts touch the base.
Use caution when handling stand base, as the isolation spikes are
sharp and can scratch wooden floors.
sharp and can scratch wooden floors.
Fig. 1
Allen wrench
d - Inner
post.
b - Outer
post.
c - Adjustable
post assembly
(2).
#8c
4mm
#8
#8h
Fig. 2
Base and keyhole
(g)
bracket
(Klipsch ProMedia)
45 deg.back
(h)
bracket (Klipsch)
90 deg.back
(m)
bracket
Angle bracket
(Klipsch)
(o)
Fig. 3
Inner
post. (d)
Outer
post. (b)
Set screw
Fig. 6
Fig. 7
foam dampening
pads
move rails
all of the way
out
STEP 2 – Attach the post assembly.
Locate adjustable post assembly (c). Loosen set screw (see Fig. 3) on
back of outer post (b) using supplied Allen wrench.
Turn adjustable post assembly upside down and gently shake it until inner
post (d) becomes accessible. Pull inner post out approximately six inches.
Rotate inner post until speaker wire port is in line with set screw, and then
re-tighten set screw.
re-tighten set scre
Insert speaker wire into speaker wire port, run wire down through adjustable
post assembly, and then thread it through center hole in top of speaker base.
Be sure to leave enough slack at the ends so that wire doesn't get pulled
out during remainder of assembly process. Attach adjustable post assembly
to speaker stand base with two base post screws (l), as shown in Fig. 1,
being careful not to pinch speaker wire. Make sure that speaker wire port is
pointing away from the front of the base, which is marked with
pointing away from the front of the base, which is marked with
OmniMount label.
STEP 3 - Select the appropriate speaker adaptor. See Figure 2.
If your speaker comes with a threaded insert in the back or
on the bottom, use bracket (g), (h), (j), (m) or (o).
For brackets (h), (m) or (o), go to step 4.
For keyhole bracket (g), go to step 4.2.
If your speaker does not come with a mounting insert, you will need to
If your speaker does not come with a mounting insert, you will need to
use the clamping mechanism (f).
For clamping mechanism, go to step 4.1.
Fig. 4
Fig. 5
mounting
side rails
screw(k)
Inner
post. (d)
side rails fit
snugly against
equal distance
speaker
on both sides
knob
Advertisement
