Advertisement
Before you start,,,
Your safety and the safety of
others are very important,
We have provided many important
safety messages in this manual and
on your appliance. Always read and
obey all safety messages.
This is the safety alert
symbol.
This symbol alerts you to
potential hazards that can kill or hurt
you and others.
All safety messages will follow the
safety alert symbol and either the
word "DANGER" or "WARNING".
These words mean:
You can be killed or seriousJy
injured if you don't immediately
follow instructions.
You can be killed or seriously
injured if you don't follow
instructions.
All safety messages will tell you
what the potential hazard is, tell you
how to reduce the chance of injury,
and tell you what can happen if the
instructions are not followed.
important:
Observe
aJJ governing
codes
and ordinances,
Proper installation
is your responsibility.
Have a qualified technician install this
oven,
Oven location should be away from
strong draft areas, such as windows,
doors and strong heating vents.
Cabinet opening dimensions
that are
shown must be used. Given dimensions
provide minimum ciearance.
Recessed installation
area must provide
complete enclosure around the recessed
portion of the oven.
Electrical ground is required. See
"Electrical requirements."
Electrical supply outlet should be
located in the rear wall on the lower right
side of the cutout or in an adjacent
cabinet. The outlet must be recessed. If
the electrical outlet is located in an
adjacent cabinet, provide a 1o3/8" dia.
minimum power supply cord plug
clearance hole in the back of the cutout or
support surface.
Oven support surface MUST be solid,
level and flush with bottom of cabinet
cutout.
There is no provision to level the oven
after it has been installed, If the
installation
is not level, the door may
slide open or not seal tightly allowing
heat to escape resulting in poor oven
performance.
It is the customer's
responsibility:
To contact a qualified electrical
installer,
To assure that the electrical
installation is
adequate and in conformance with
National Electrical
Code, ANSI/NFPA 70
E latest edition*, or CSA Standards
022.1-94, Canadian Electrical Code, Part 1
and 622 No, 0-M91 E latest edition** and
all local codes and ordinances,
Copies
of the standards
listed may be obtained
from:
* NationaJ
Fire Protection
Association
One Batterymarch
Park
Quincy,
Massachusetts
02269
e* Canadian
Electrical
Association
178 Rexdale
BouJevard
Etobicoke
{Toronto),
Ontario
MSW 1R3
Toolsneededfor
Partssupplied:
Phillips
screwdriver
/
Advertisement
