Advertisement
G
before using your Kenwood
Only the appropriate power supply
appliance
connector must be used with this
G
Read these instructions carefully and
appliance.
G
retain for future reference.
Do not use the appliance outdoors.
G
G
Remove all packaging and any
This appliance is not intended for
labels.
use by persons (including children)
with reduced physical, sensory or
safety
mental capabilities, or lack of
experience and knowledge, unless
G
Do not immerse the supply cord or
they have been given supervision or
power supply connector in water or
instruction concerning use of the
other liquid.
appliance by a person responsible
G
Never use a damaged appliance,
for their safety.
cord or plug. Get it checked or
G
Children should be supervised to
repaired: see 'service'.
ensure that they do not play with the
G
Do not let the cord hang over the
appliance.
edge of the table or worksurface or
G
Only use the appliance for its
touch hot surfaces.
intended domestic use. Kenwood
G
Never use the wok empty.
will not accept any liability if the
G
The wok and contents will remain
appliance is subject to improper use,
hot after use.
or failure to comply with these
G
The wok should not be used near or
instructions.
below curtains and other
before plugging in
combustible materials.
G
Make sure your electricity supply is
G
Do not place this appliance on or
the same as the one shown on the
near a naked flame, electric burner,
underside of your wok.
hot plate or in a heated oven.
G
Do not touch hot surfaces - use
Important – UK only
handles or knobs.
G
G
Always unplug and remove the
The wires in the cord are coloured
power supply connector from the
as follows:
wok when not in use and before
Blue = Neutral,
cleaning.
Brown = Live.
G
G
Take care when removing the power
The appliance must be protected by
supply connector as the probe may
a 13A approved (BS1362) fuse.
be hot.
Note:
G
Never leave the wok unattended
G
For non-rewireable plugs the fuse
when in use.
cover MUST be refitted when
G
Always attach the power supply
replacing the fuse. If the fuse cover
connector to the appliance first, then
is lost then the plug must not be
plug into the power supply. To
used until a replacement can be
disconnect, remove the plug from
obtained. The correct fuse cover is
the power supply first before
identified by colour and a
removing the power supply
replacement may be obtained from
connector from the appliance.
your Kenwood Authorised Repairer
(see Service).
2
Advertisement
