PREPARATION
STAND INSTALLATION
■
Image shown may differ from your TV.
■
When assembling the desk type stand, check
whether the bolt is fully tightened. (If not tight-
ened fully, the product can tilt forward after the
product installation.) If you tighten the bolt with
excessive force, the bolt can deviate from abrasion
of the tightening part of the bolt.
1
Carefully place the TV screen side down on a cushioned
surface to protect the screen from damage.
2
Assemble the TV as shown.
Fix the 4 bolts securely using the holes in the
3
back of the TV.
!
NOTE
When assembling the stand, make sure to distinguish
G G
and assemble the front and rear side of the stand
correctly.
8
BACK COVER FOR
WIRE ARRANGEMENT
■
Image shown may differ from your TV.
After Connecting the cables as necessary, install
CABLE HOLDER as shown and bundle the cables.
NOT USING THE DESK-TYPE STAND
■
Image shown may differ from your TV.
When installing the wall-mounted unit, use the protection
cover. Insert the P P R R O O T T E E C C T T I I O O N N C C O O V V E E R R into the TV
until clicking sound.
DESKTOP PEDESTALINSTALLATION
For adequate ventilation allow a clearance of 4"
(10cm) all around the TV.
FRONT
4 inches
CABLE HOLDER
protection cover
4 inches
4 inches
4 inches