Belkin PLAY N600 DB User Manual page 33

TrOUBlEshOOTing
limiting the wireless transmit rate – Limiting the wireless
transmit rate can help improve the maximum wireless range, and
connection stability . Most wireless cards have the ability to limit
the transmission rate . To change this property, go to the Windows
Control Panel, open "Network Connections" and double-click on
your Adapter's connection . In the "Properties" dialog, select the
"Configure" button on the "General" tab, then choose the "Advanced"
tab and select the rate property . Wireless client cards are usually
set to automatically adjust the wireless transmit rate for you, but
doing so can cause periodic disconnects when the wireless signal
is too weak; as a rule, slower transmission rates are more stable .
Experiment with different connection rates until you find the best
one for your environment; note that all available transmission
rates should be acceptable for browsing the Internet . For more
assistance, see your wireless card's literature . If issues persist
even at close range, please contact Belkin Technical Support .
The Adapter does not perform or connection is unstable
when computer has a second built-in wireless network
card (such as a mini PCI or Intel
This condition occurs if your computer has a built-in wireless
card while your Belkin Play N600 Wireless Dual-Band usb
adapter is also active . This happens because Windows
must now handle two active wireless connections .
You must disable the built-in wireless card from your computer
under "Network Adapters" in the Device Manager .
31
Centrino™).
®