LG LMV1680BB Installation Instructions Manual page 16

STEP 5: Install The Mountincl Plate
For Wall-Vented
• Make the box cutout for the rear wall duct.
- 1-piece mounting plate:
Using a pencil, put dots through slots F and G, and
through holes H and I. Remove the mounting plate and
draw lines extending through the points. This will give
the location and size of the box cutout for the rear wall
duct. (Figure 29)
- 3-piece mounting plate:
Use the wall template to determine the location and size
of the box cutout for the rear wall duct.
• Attach the exhaust adaptor to the rear mounting plate
(back plate) wall side. Push in securely until it is past the
top locking tabs and in the lower locking tabs. Take care to
assure the damper hinge is installed so that it is at the top
and that the damper swings freely.
• Carefully guide the exhaust adaptor, now attached to the
mounting plate, into the house duct. Before using the
screws to attach the plate to the wall. This will assure
proper alignment for installation.
• After completing the installation of the mounting plate,
again check the rear damper for free movement to assure
it will operate properly.
Figure 29
Exhaust A daptor
Slide
exhaust
_
adaptorinto x
guides on
rearpanel. I:i_'
OpU:;:g Plate
MountingPlate)
.,,/_r" _[1 BackPlate
MouotingPlare)
Locking
Tabksing /
Guides
Figure 30
-16-