Fcc Class B Statement - HP D8891A User Manual

Notice for the USA: FCC Class B Statement
Federal Communications Commission radio Frequency interference Statement Warning:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communication. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the distance between the equipment and the receiver.
Connect the equipment to an outlet on a different circuit to the one the receiver is connected to.
Consult your dealer or an experienced radio/TV technician for help.
Hewlett-Packard's FCC Compliance Tests were conducted using HP-supported peripheral devices and
HP shielded cable, such as those you receive with your system. Changes or modifications not expressly
approved by Hewlett-Packard could void the user's authority to operate the equipment.
Notice for Canada
The Class "B" digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la Classe B respecte toutes les exigences du réglement sur le matériel
brouilleur du Canada.
X-Ray Radiation Notice
When operating, this product emits x-rays; however, it is well shielded and meets the safety and health
requirement of various countries, such as the Radiation Act of Germany and the Radiation Control for
Health and Safety act of the United States.
Radiation emitted by this product is less than 0.1mR/hr(1uSv/hr) at a distance of 10 centimeters from
the surface of the cathode ray tube. The x-ray radiation primarily depends on the characteristics of the
cathode ray tube and its associated low voltage and high voltage circuitry. Internal controls have been
adjusted to ensure safe operation. Only qualified personnel should perform any internal adjustments as
specified in the service manual for this project.
Replace the cathode ray tube with an identical CRT only.
Safety Warning for USA
If the power cord is not supplied with your monitor, select the proper power cord according to your
national electric safety codes.
USA: use a UL listed detachable power cord.
8