Advertisement
Automatic Shutoff Light
The light comes on when the iron is plugged
in, even if the temperature control dial is
set at Off. The light indicates the iron is
plugged in.
The iron will shut off and the light will go
out one hour after it is plugged in. When
the light goes out unplug the iron and
plug back in to reset.
Reversible Cord
Some irons have a reversible cord. The cord
can be moved from one side to the other, to
accommodate right- or left-handed users.
Unplug iron. Remove screw and back cover
as shown. Move cord as desired and
replace back cover and screw.
WARNING: To prevent risk of electrical shock
unplug iron before reversing cord.
Swivel Cord
For irons with a swivel cord, rotate the cord
to the desired position for ironing.
Wrap & Snap Cord
When finished ironing, let the iron cool then
wrap cord and secure with the Wrap & Snap
on the plug.
6
6
FABRIC/SETTING CHART
Setting
To Iron
0
Off
Acetate, Silk
1
2
Acrylic, Nylon
3
Polyester, Rayon
4
Cotton Blends
Wool
5
6
Cotton
7
Linen
CARING FOR YOUR IRON
1. Turn temperature control dial to OFF. Push the STEAM or
DRY IRON/CLEAN switch to DRY IRON/CLEAN. Unplug
and let cool. The iron takes longer to cool down than it does
to heat up.
2. To empty water from iron, slowly tilt pointed end of iron
down over a sink. Water will run out of water tank opening.
3. Wrap cord loosely around iron and store iron in an upright
position. Do not store iron laying flat on soleplate.
CARING FOR THE SOLEPLATE
1. Never iron over zippers, pins, metal rivets, or snaps, as
these may scratch the soleplate.
Ironing Instructions
Dry iron on the wrong side of
the fabric.
Dry iron using spray if necessary.
For polyester, dry iron while the
fabric is still damp.
Iron using steam or spray for
difficult wrinkles.
For wool, use a press cloth and
steam iron on the wrong side.
Iron cottons while still damp,
using steam and/or spray.
Iron on wrong side of fabric
while still damp.
7
7
Advertisement
