Selecting The Programme; Starting The Cycle - Hoover Washer Dryer Instruction Book

40002934Eng.qxd 24/04/2005

Selecting the programme

30
13:30 Page 30
Refer to the Programme Guide or the programme
descriptions on the front of the machine to select
the most suitable programme.
The programme is selected by turning the
programme selector and aligning the programme
name with the indicator.
Check that the STOP indicator is flashing, if not
check that the door is properly closed.
Check that the tap is turned on and that the
discharge hose is positioned correctly.
Select the required wash options.
Select the appropriate drying time
based on the table to be found on
page 23.

Starting the cycle

Press the Départ/Pause button. The Porte Sécurisée
indicator and the DEPART light illuminate, within a
few seconds the programme will begin.
Do not try to open the door when the Porte
Sécurisée indicator is on.
Do not open the dispenser drawer during the
wash programme.
If you wish to pause the programme press the
Départ/Pause button and after 2 minutes the
door can be opened. To cancel the programme
the Départ/Pause button must be pressed down
for five seconds. To signify that the programme
has been cancelled the "STOP" light in the
"TEMPS RESTANT" indicator will light. A new
programme can be selected after cancelling the
programme.
To test the laundry for dryness
When completing the drying phase it is possible to
check the load for dryness.
Press the Départ/Pause button, the machine will go