Advertisement
INSTALLATION
REQUIREMENTS
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions
3rovided with any tools
listed here.
•
Measuring tape
•
Electric drill
•
Pencil
•
5/64" (2 mm) drill bit
•
T10 TORX ®tscrewdriver
Parts Supplied
All of the following parts are provided, but not all parts will be
used. The cutout opening size will determine which parts you will
use. See chart below parts list to see which parts are used for
each installation.
The microwave oven may be located in a cabinet, and/or above a
built-in oven, or below the counter and/or below a non-vented
cooktop. Check the opening where the microwave oven will be
installed. The location must provide:
•
Wood cabinetry.
•
Cutout opening that is plumb and square. See "Minimum
Cutout Dimensions" in "Minimum Dimensions" section.
•
Cutout floor that is solid, level and flush with bottom of
cabinet cutout.
•
Support for weight of at least 150 Ibs (68 kg), which includes
microwave oven and items placed inside.
•
Grounded electrical outlet. See "Electrical Requirements"
section.
•
Minimum installation clearances for installation location. See
"Minimum Dimensions" section.
We recommend:
•
Complete enclosure around the recessed portion of the
microwave oven.
D
E
A. Side brackets (2)
B. Removable
extension plates
(shaded piece, 2)
C. 1" T-lO screws (6)
D. Narrow side trim panels (2)
E. Wide side trim panels (2)
INSTALLATION
PARTS USED
24" (61.0 cm) installation
C
27" (68.6 cm) installation*
A, C, D
30" (76.2 cm) installation
A, B, C, E
*Extension plate (B) will have to be removed from side bracket (A)
for this installation.
1-®TORX is a registered trademark
of Textron Innovations
Inc.
Advertisement
