Table of Contents
Advertisement
40000140.qxd
27-06-03
Condenser
Support the container with both hands.
When full, the water container will
weigh about 4kg (fig. 7).
7
3. Open the lid located on the top of the
container and empty the water (fig. 8).
8
4. Refit the lid and slide the water
container back into position. PUSH
FIRMLY INTO PLACE.
5. Refit the kickplate by engaging the
hinges at the top and 'snapping' the
lower clips into place.
Condenser
IMPORTANT: Always switch off and
remove the plug from the electricity
supply before cleaning the condenser.
To maintain the efficiency of the dryer
regularly check that the condenser is
clean.
To remove the condenser:
1. Remove the kickplate (fig. 5).
15:06
Page 7
2. Turn the two locking levers anti-
3. Pull out the condenser unit (fig. 10).
4. Gently remove any dust or fluff with a
5. Refit the condenser ensuring it is
6. Refit the kickplate.
clockwise (fig. 9).
9
10
cloth, then wash the unit by holding it
under a running tap (fig. 11) turning it
so that water flows between the plates,
to remove any dust or fluff.
11
pushed firmly into place. Lock the two
levers by turning them clockwise.
7
Advertisement
Table of Contents
