Page 1
Model 2641223 OWNER’S MANUAL Marine Audio System • PLL Synthesizer Stereo Radio • Digital Compact Disc Player • Automatically Memory Storing • Fold Down Full Detachable Panel • Auxiliary Input Function • Preset Equalization • Remote Control (OPTIONAL)
CONTENTS Installation .....................3 DIN Front-Mount (Method A) ..................3 Installing the unit ....................3 Removing the unit .....................4 DIN Rear-Mount (Method B) ...................4 Using the Detachable Front Panel ................5 Wiring Connection ..................6 Operation .......................7 General Operation ....................7 Radio Operation......................8 CD Operation ......................9 Specification....................10 Trouble Shooting ..................11...
INSTALLATION Notes: DIN FRONT-MOUNT (Method A) • Choose the mounting location where Installing the unit the unit will not interfere with the normal driving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly.
Removing the unit Fastening the unit to the factory radio mounting bracket. 1. Select a position where the screw holes of the bracket and the screw holes of the main unit become aligned (are fitted), and tighten the screws at 2 places on each side.
USING THE DETACHABLE FRONT PANEL To Detach the Front Panel To Reinstall the Front Panel 1. Press the open button (OPEN), then 1. Push the front panel into the main the front panel will be folded down. body. A ‘click’ sound should be heard.
WIRING CONNECTION MAIN UNIT ANTENNA CONNECTOR IGNITION ORANGE SWITCH (B+) (GREY) Rch RED RCA CABLE MEMORY BACK-UP Lch WHITE BLACK GROUND (B–) BROWN GREY FRONT Lch FRONT Rch SPEAKER SPEAKER BROWN/BLACK GREY/BLACK GREEN VIOLET REAR Lch REAR Rch SPEAKER SPEAKER GREEN/BLACK VIOLET/BLACK...
OPERATION 11 10 15 18 23 24 GENERAL OPERATION • ON/OFF/ILLUMINATE • SOUND ADJUSTMENT Switch on the unit by pressing any Press SEL button (10) shortly to select button (Except OPEN button and the desired adjustment mode. EJECT button). When system is on, The adjustment mode will change in press /ILL button (9) shortly to...
OPERATION • LOUDNESS • RESET Press BND/LOU button (13) to Reset button (24) is placed on the front increase bass output and display will panel and must be activated with either show “LOUD”. Press it again to a ball point pen or thin metal object. release this function.
OPERATION This function is effect during AUTO • PAUSE PLAYING SEEK operation. Press PAU button (19) to pause CD player. Press it again to resume play. • MONO/STEREO Press MON button (1) to select mono • REPEAT THE SAME TRACK or stereo mode.
SPECIFICATION GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 165 (D) x 50 (H) Tone Controls - Bass (at 100 Hz) 10 dB - Treble (at 10 KHz) 10 dB Maximum Output Power : 4 x 35 Watts Current Drain : 10 Ampere (max.)
TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition switch is If the power supply is properly not on.