Zenith C27J28C Operating Manual page 18

TV operation
NOTE:
After 10 seconds, DISPLAY screen will
return to normal TV-operation
automatically, when a Digital signal is
received.
After 4 seconds, DISPLAY screen will
return to normal TV-operation
automatically, when an Analog signal is
received.
18
J33A0621B_EN.indb 18 J33A0621B_EN.indb 18
CH /
Press and release CH or
The channel automatically stops at the next
channel set into memory.
For proper operation, before selecting
channels, they should be set into the
memory. See pages 14 - 16
"Memorizing channels".
DISPLAY
Press –/DISPLAY to display the current
information on the screen.
When the TV receives a digital signal,
the digital information will appear.
• Broadcast program name
• Station name
• Audio language
• Program name
• V-CHIP RATING
When the TV receives an Analog signal,
press –/DISPLAY again, the analog
information will appear.
• Clock
• Channel number or VIDEO mode selected
• Stereo or SAP (second audio program)
audio status
• Picture size
Press –/DISPLAY again to clear the call display.
QUICK VIEW
This button allows you to go back to the
last channel selected by pressing QUICK
VIEW. Press QUICK VIEW again to return
to the last channel you were watching.
MUTE
Press MUTE to switch off the sound.
The unit's sound will be silenced and
"MUTE" will appear on the screen.
The sound can be switched back on by
pressing this button again or one of the
VOL + or – buttons.
SLEEP
To set the unit to turn off after a preset amount
of time, press SLEEP on the remote control.
The clock will count up 10 minutes for each
press of the SLEEP button (0, 10, 20, ...100,
110, 120).
After the sleep time is programmed, the
display will appear briefl y every ten minutes to
remind you that the sleep timer is operating.
To confi rm the sleep timer setting, press SLEEP and the remaining
time will be displayed for a few seconds. To cancel the sleep timer,
press SLEEP repeatedly until the display turns to 0.
(continued)
.
1/31/08 5:31:27 PM 1/31/08 5:31:27 PM