Snooze Setting; Lcd Screen; Manual Time Setting - La Crosse Technology RADIO CONTROLLED PROJECTION CLOCK WITH DIGITAL THERMOMETER Instruction Manual

To set alarm:
1. Press and hold the AL/HR key, the (((•))) icon will appears and the AL icon on the LCD starts flashing.
2. Set the hours and minutes of the desired alarm time by use of the AL/HR (hours) or the MODE/MIN
(minutes) keys respectively.
3. Once the alarm time is set, press the SNOOZE key to confirm and exit or wait approximately 8 seconds
for automatic timeout.
TO ACTIVATE / DEACTIVATE THE ALARM:
Press the AL/HR key. The alarm icon (((•))) will appear/disappear indicating that it is ON or OFF.
Note: the maximum duration of the alarm ringing is 1 minute 36 seconds.

SNOOZE SETTING:

The snooze time is set as default for 5 minutes by the manufacturer. The snooze mode will be activated from
the start of next minute after the SNOOZE key was pressed – it does not count the current minute that it was
pressed in.
To use the snooze feature, simply press the SNOOZE key when the alarm is sounding and the alarm will
snooze for 5 minutes before automatically sounding again. When the alarm is snoozing, the alarm icon (((•)))
will start flashing indicating that the alarm is active but is in Snooze mode.
To stop the snooze function, press the AL/HR or the MODE/MIN key once.

LCD SCREEN

The Projection clock can display information of date, indoor temperature, seconds and alarm time on the LCD
only. The projection will only display the time.
The clock LCD can alternate between the 4 display modes when pressing and the MODE/MIN key:
Time
DCF-77
Tower icon
Indoor temperature
Date display
display in degree
Celsius

MANUAL TIME SETTING:

Hours Setting
(flashing)
In some cases after inserting the batteries, the Projection clock may not be able to receive the DCF-77signal. In
this situation, the time should be manually set (before manual setting see Checking DCF-77 Reception
above).
1. Press and hold the MODE/MIN key firmly while inserting the batteries until the time digits start flashing.
2. Set the time by using the AL/HR and the MODE/MIN keys respectively.
Seconds display Alarm time display
Minutes Setting
(flashing)