Hamilton Beach Tango Series Operation Manual
Tango series bar blenders
Hide thumbs
Also See for Tango Series:
- Operation manual (33 pages) ,
- Operation manual (21 pages) ,
- Operation manual (40 pages)
Subscribe to Our Youtube Channel
Related Manuals for Hamilton Beach Tango Series
Summary of Contents for Hamilton Beach Tango Series
- Page 1 Tango Series Bar blenders Operation Manual 840083701-UK www.commercial.hamiltonbeach.com...
-
Page 2: Blender Safety
Purchase Date _________________________ Dealer Name ___________________________ Dealer Address _________________________ Dealer Phone___________________________ You can also order replacement parts by calling your nearest Hamilton Beach Commercial Service Center or your local dealer. 8 a.m. – 5 p.m. EST Monday – Friday (www.commercial.hamiltonbeach.com) wWARNING... -
Page 3: Important Safety Instructions
• Close supervision is necessary when any appliance is used by or near children. • The use of accessory attachments not recommended by Hamilton Beach may cause injuries. • To reduce risk of personal injury, unplug cord from outlet when not in use, and before putting on or taking off parts or doing any other servicing of the blender. -
Page 4: Parts And Features
Parts and Features The parts and features for the Tango Series Blenders are shown on this page. Become familiar with all parts and features before using your blender. Your Tango Series blender is designed for blending and mixing beverages. NOTE: The Blender is not designed to crush ice. Ice cubes made in most icemakers may be added to liquid ingredients in the blender to make daiquiris or similar drinks. -
Page 5: Operation
Controls Two separate switches on the front panel allow you to control the blender for precise blending requirements: • The On/Off switch will turn the blender On for continuous operation or Off. • The Pulse position on the On/Off switch (Model 91300 only) turns on the blender only when the switch is pressed. - Page 6 Blending techniques Icy drinks – Do not use blender to crush large ice cubes. The blender is not designed for this. Small ice cubes or crushed ice is recommended. Pour in liquid, then add ice.
-
Page 7: Caring For The Blender
6. Remove any remaining moisture from cutter assembly by replacing container on base with cover and filler cap in place. Then run blender on HiGH speed for a minimum of 2 minutes. 7. To dry, place empty container on base and run on HIGH speed for two seconds. -
Page 8: Troubleshooting Guide
Do not attempt to repair or tighten the cutter assembly. See “Replacement Parts” below. Weekly Unplug the blender, and then inspect the power cord insulation and power plug for cracks. Refer to “Requesting Assistance or Service” for repair or replacement.
Need help?
Do you have a question about the Tango Series and is the answer not in the manual?
Questions and answers