Problems And Causes; Limited One Year Warranty - Krups NOVO COMPACT Instructions For Use Manual

Place the sieve back Into the brewing head
and screw firmly Into place (see figure 26).
The steam nozzle must be wiped with a
mOist cloth Immediately after frothing.
This will prevent the milk from drying onto
the nozzle and clogging the steam hole.
However, should the nozzle become
clogged, the nozzle can be removed with a
COinand cleaned uSing a needle. Ensure the
rubber nng ISIn position when replacing the
steam nozzle (see figure 27).
If the machine will not be used for any length
of time, we recommend not leaving the filter
holder Inside the brewing head, as this puts
'the sealing nng under unecessary pressure,
which can shorten the life ofthe sealing nng.
Decalcifymg.
Under normal conditions you do not need to
decalcify your ~Novo Compact~rNovo
Compact Latte" However, In areas where
there IShard water or if you use your machine
very frequently we recommend decalcifying.
"Youwill know when such a cleanrng IS
necessary by an obvIous slow down In the
brewing time. Decalcifier ISwJdely available
and can be purchased through KRUPS
Consumer Service Department.
How To Decalcify
. Before beginning, it IS necessary to
remove the brewing sieve
from the
brewing head (see figure 26). This can be
done uSing a flat head screw dnver or COin.
.
Remove the water reservoir and fill it with
luke warm water. Dissolve the decalcifying
solution IOtO the water reservoir. Replace
the water reservoIr.
14
..
. Place a cup underneath the brewing spout.
. Turnthe control dial to the"
.Q' " position.
Stop between each cup and empty it as it
becomes full. Proceed with this until all of
the water has run through the machine.
Allow the appliance to cool for 10-15
minutes when done.
. To eliminate traces of the decalcifying
solution, fill the water reservoir with
fresh, cold water.
. Turn the control dial to the" .Q' " position
and clean the machine until there ISno
more water In the reservoir.
Problem:
Coffee does not come out of filter holder.
Cause:
. No water In the water reservoir.
. Water reservoir not Inserted correctly.
. Filter blocked because the coffee mixture
IStoo fine or has been tamped too hard.
. Machine needs to be decalcified.
Problems and Causes
Problem:
Espresso has no "Crema"
Cause:
. Old or dried out coffee being usee.
. Coffee not suitable for espresso.
. Coffee ground too coarsely.
. Too little coffee In the filter or not
properly tamped.
Problem:
Coffee leakmg from filter holder.
Cause: Problem:
Not enough froth when frothrng milk.
Cause:
. Steam nozzle IS clogged.
. Milk IS not fresh.
. The pitcher that you are using ISnot suitable.
(It IS recommended that you use a starnless
steel.frothlng pitcher.) Cold conducts
better to metal than to glass or plastic.
. The type of milk IS not suitable. We
recommend uSlOg 2% or skim milk.
Whole milk IS acceptable, but due to the
fat molecules, it will not have as dense a
froth as if you were to use 2% or skIm milk.
. Filter holder not properly Inserted In the
machine.
. Filter holder not pushed In as far as it will go.
Problem:
Pump makes. loud nOise.
Cause:
. No water 10the water reservoir.
. Old or dry coffee ISberng used, water
cannot properly flow through the coffee.
Limited
One Year Warranty
Your KRUPS #989 or 882 IS covered by the
following warranty:
If from date of purchase within one year thIs
KRUPSproduct fails to function because of
defects 10matenals or workmanship,
KRUPS
North Amenca will, at its option,
repair
or
replace the unit with our charge,
provided the owner has a proof of date of
purchase.
.
This warranty will be vOid jf malfunction
was caused by damage to the product by
accident, misuse, use on frequency or
voltage other than marked on the product
and/or described In the Instructions, abuse
IOcluding tampenng, damage In transit, or
use for commercial purposes. This warranty
gives you specificlegal nghts, and you may
also have other rrghts which may vary from
state to state.
15