Samsung HT-C6730W User Manual page 41

5. In the list o fnetworks, press theAT
buttons toselect anetwork, and then press
the ENTER button,
6. Ifthe PIN/Security pop-up appears, goto
Step 7 .Ifthe Network Connecting Screen
appears, go toStep 1 1.
7. Press theAT buttons toselect PIN or
Security.
For m ost home networks, you would select
Security (for S ecurity Key),
8. On the Security screen, enter your network's
Pass Phrase,
NOTE
_ You should beable t ofind the Pass Phrase
onone ofthe set u p screens you used toset
up your router ormodem.
9.
To enter the Pass Phrase, follow these
general directions:
• Press the number keys on your remote to
enter numbers,
• Use the arrow keys on your remote to
move from button to button on the
Security Key screen,
• To enter letters, move to the button
labeled a/A/U*, and then press the
ENTER button. Each time you press the
ENTER button, you change the kind of
characters you can enter (a/A/I/*).
• To enter a letter, press the number button
that corresponds to the letter. Pressing
the button repeatedly changes the letter,
• To delete the last letter or number you
entered, move to the Delete button, and
then press the ENTER button,
• To clear all entered letters and numbers,
move to the Clear key, and then press the
ENTER button. You can also just press
the RED (A) button on your remote,
10. When done, press the YELLOW (C) button
on your remote, or move to the Done
button, and then press the ENTER button,
The Network Connecting screen appears,
11. Wait until the connection confirmation
message is displayed, and then press the
ENTER button. The Network Settings
screen reappears,
12. To test the connection, press the V button
to select Network Test, and then press the
ENTER button,
Setting Up the Wireless Network
Connection - Manual
If the Auto Setting does not work, you need to
enter the Network settng values manually.
To get the Network setting values from most
Windows computers, follow these steps:
1. Right click the Network icon on the bottom
right of the screen.
2. In the pop-up menu, click Status,
3. On the dialog that appears, click the
Support tab.
4. On the Support tab, click the Details button,
The Network settings are displayed,
To Enter the Network settings into your product,
follow these steps:
1. On the Intemet Protocol Setup screen,
press the ENTER button,
2. Press the A T buttons to select Manual,
and then press the ENTER button,
3. Press the T button to go to the first entry
field (IP Address),
4. Use the number buttons to enter numbers,
iiii
English
41