Power On/Off; Turning On The Power - Hitachi CPX10WN Manual

Power on/off

Turning on the power

1.
Make sure that the power cord is  rmly and
correctly connected to the projector and the
outlet.
2.
Make sure that the POWER indicator is
steady orange (
lens cover.
3. Press STANDBY/ON button on the
projector or the remote control.
The projection lamp will light up and POWER
indicator will begin blinking in green. When the
power is completely on, the indicator will stop blinking and light in steady
100).
green (
To display the picture, select an input signal according to the section Selecting an
22).
input signal (
The INITIAL SETTING Menu will be displayed by factory default upon startup.
Once the INITIAL SETTING Menu is set, it will not appear until FACTORY RESET
62) is executed. If you wish to change the settings, refer to the LANGUAGE
(
47) and ALTITUDE (
(
(1) LANGUAGE: Use the ▲/▼/◄/►
buttons to select the desired language
and press the ENTER button of the
remote control or the INPUT button of
the projector to execute.
(2) ALTITUDE: Use the ▲/▼ buttons to
select NORMAL for altitude below
1600 m (5250 feet), otherwise select
HIGH and press the ENTER button of
the remote control or the INPUT button
of the projector to execute.
100). Then remove the
57) menu.
Power on/off
STANDBY/ON button
POWER indicator
VIDEO COMPUTER MY SOURCE/
DOC.CAMERA
ASPECT AUTO SEARCH
MAGNIFY FREEZE PAGE
ON
OFF DOWN
MY BUTTON
KEYSTONE 1
POSITION
ENTER
ESC
BLANK
VOLUME
UP
2 MUTE
MENU
RESET
19