Major Operating Controls And Their Functions - Panasonic BM-ET300 Setup Manual

MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS

<Rear Panel>
w
Rear tamper detection switch
qwFront/Rear tamper detection switch
These switches protect the internal data and setup data
of the iris camera. While the front cover is properly
closed, the front tamper detection switch is pressed
and the camera is in the "normal operation" mode.
While the iris camera is attached to the wall, the rear
tamper detection switch is pressed and the camera is
in the "normal operation" mode.
If the front cover is opened or the iris camera is
removed from the wall, while the power is on, the
front/rear tamper detection switch will be activated and
the iris camera enters the "tamper detection" mode.
When the switch becomes activated, the tamper detec-
tion buzzer will work and the iris server will be notified
that the iris camera has entered the "tamper detection"
mode. At the same time, an alarm signal will be output
from the alarm output2 (tamper detection) terminal on
the connection terminal. (The iris data will be erased
from the iris camera.) If the tamper detection mode is
not cancelled in a given time, the setup data and oper-
ation software will be erased from the iris camera. In
this case, it is necessary to retry the setup, as the iris
camera will be set to the factory default.
When either of the front/rear tamper detection switch
works, the iris camera enters the "tamper detection"
mode. This mode can be cancelled by setting Setup
switch 3 to ON. (Cancel the "tamper detection" mode
before connections or setup by referring p. 12.) After
setup, when the cover is closed after Setup switch is
set to OFF, the iris camera is automatically reset. Then
the "normal operation" mode will be recovered.
Note: Mount the iris camera to the flat and firm wall.
Otherwise, the tamper detection switch will not be
pressed and the iris camera cannot enter the "nor-
<Rear Panel>
q
e
mal operation" mode.
e LAN connector
This connector, supporting 10 Base-T/100 Base-TX, is
used for communication with the iris server.
r Setup cable connector
BM-ET300 Setup Cable (an exclusive cable supplied to
the administration software) will be connected between
this connector and the serial port of the setup PC.
Note: Refer to pp. 11 to 15 "SETUP PROCEDURE" for
details.
t Setup switches
These switches are used for changing the mode of the
iris camera at the time of setup. The assignments are as
follows.
In the factory default setting, all the switches are set to
OFF.
Switch
Use
No.
Operation mode "Normal opera-
1
change tion" mode
Booting pro- Default booting
2
gram change
program
"Tamper detec- The "tamper
tion" mode acti- detection" mode
3
vation/cancella- is cancelled.
tion
4 Unused
ON (Upper side)
1 2 3 4
y
t
r
ON OFF
"Setup" mode
Normal booting
program
The "tamper
detection" mode
is activated.
– –
9