Toshiba D-R4SU Owner's Manual page 3

Note to cable system installer:
This reminder is provided to call the cable system installer's attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected
to the grounding system of the building, as close to the point of cable entry as practical.
The instructions shall state that an ALL-POLE MAINS SWITCH with a contact separation of at least 3 mm in
each pole shall be incorporated in the electrical installation of the building.
CAUTION:
These servicing instructions are for use by qualified service personnel only. To reduce the
risk of electric shock do not perform any servicing other than that contained in the operating
instructions unless you are qualified to do so.
In the spaces provided below, record the Model and Serial No. located on the rear panel of your recorder.
Model No. Serial No.
Retain this information for future reference.
Location of the required label
PRODUCTISCERTIFIED BYTHE
MANUFACTURERTO COMPLY
WITH DHRS RULE 21 CFR
SUBCRAPTERJ IN EFFECTAT
DATEOF MANUFACTURE,
TOSHIBA CORPORATION
1-1 ,SHIBAURA 1-CHOME,MINATO-KU,
TOKYO 105-8001 ,JAPAN
3