Whirlpool GU3100XTVS0 Installation Instructions Manual page 10

3=
4=
Attach the drain hose to the air gap with the large spring-type
clamp.
NOTE: If the drain hose was cut, use 1V2"to 2" (3.8 to 5 cm)
screw-type clamp (not provided).
Use a rubber hose connector (not provided) with spring- or
screw-type clamps (not provided) to connect the air gap to the
waste tee above the drain trap and at least 20" (50.8 cm)
above the floor.
B
E
A. Drain hose-- cut here, if needed
B. Spring- or screw-type clamps
C. Air gap
D. Large spring-type clamp
E. Drain hose
F. Rubber hose connector
G. Waste tee
H. Drain trap
5. Insert the drain hose through the hole cut in the cabinet and to
the center front of the opening where the drain connection will
be made.
A. Drain hose
Connect Drain Hose to Waste Disposal--No Air Gap
IMPORTANT: Always use a new drain hose even when installing
a new replacement dishwasher.
1. Drill a 11/2"(3.8 cm) diameter hole in the cabinet wall or floor on
the side of the opening closest to the sink.
2. Remove the waste disposal knockout plug.
NOTE: Do not cut the end of the drain hose.
3. Attach the drain hose to the waste disposal inlet with the large
spring-type clamp.
This connection must be before the drain trap and at least 20"
(50.8 cm) above the floor.
NOTE: It is recommended that the drain hose be looped up
and securely fastened to the underside of the counter.
A
B
C
4=
A. Large spring-type clamp
B. Drain hose
C. Disposal inlet
D. Drain trap
Insert the drain hose through the hole cut in the cabinet and to
the center front of the opening where the drain connection will
be made.
A
A. Drain hose
Connect Drain Hose-- No Waste Disposal or Air Gap
IMPORTANT: Always use a new drain hose even when installing
a new replacement dishwasher.
1. Drill a 11/2"(3.8 cm) diameter hole in the cabinet wall or floor on
the side of the opening closest to the sink.
2. Cut the end of the drain hose, if needed.
NOTE: Do not cut the ribbed section.
3. Attach the drain hose to the waste tee with the 11/2"to 2"
(3.8 cm to 5 cm) screw-type clamp (not provided).
This connection must be before the drain trap and at least 20"
(50.8 cm) above the floor.
10