Connect To Water Supply - Whirlpool GU3200XTXB4 Installation Instructions Manual

Place level a gainst topfrontopening o ftub.Check t hat
dishwasher is level f romsideto side. I f dishwasher is not
level, a djust f rontlegsupor downuntildishwasher is
level.
ii /i _iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_i_i_iIiIiIiIi_
Connect to Water Supply
Be sure rubber washer is properly seated in fitting. Slide
the 3/4"fitting up to the valve and hand tighten to avoid
cross-threading. Hand tighten until the coupling is tight.
Using pliers, check the tightness of the coupling. An
additional 1/4to 1/2turn may be required to seal the rubber
gasket.
NOTE: Do not overtighten. Damage to the coupling can
result.
Place paper towel under 90 ° elbow fitting. Turn on water
supply and check for leaks. If leak occurs, repeat
previous step.
If needed, see website for animated representation
of this step. Visit www.whirlpool.eom/watersupply
under FAQ tab.
iiiiii_iii iiii_i/i i/i_iiii
Connect
to Drain
drain
loop
To help minimize vibration, route drain hose to avoid
contact with motor, door springs, water line, cabinet,
flooring or the edge of the hole where it passes through
the cabinet.
Do not remove drain loop from side of dishwasher.
Place pan under end of drain hose. Pan will collect any
water in drain hose.
Place towel under drain hose to catch any water in drain
hose. Place the small green drain hose clamp onto the
small end of the drain hose. Push the new drain hose
into the black drain hose connector up to the drain hose
stop.
Using pliers, squeeze open the small green drain hose
clamp and slide onto connector between stops.
17