Whirlpool GH7208XRQ2 Installation Instructions Manual page 11

4.
With front of oven still tilted, thread power supply cord through
the power supply cord hole in the bottom of the upper
cabinet.
For Roof Venting Installation Only
1. Insert damper assembly through the cabinet cutout so that the
long tab of the damper assembly slides into the slot on the left
side of the damper vent opening, as shown. Then secure with
mounting screw.
NOTE: The screw cannot be installed if the damper assembly is
not positioned as shown.
A B C
\
5. Rotate oven up toward upper cabinet.
NOTE: If venting through the wall, make sure the damper
assembly fits easily into the vent tube in the wall cutout.
6. Push oven against mounting plate and hold in place.
NOTE: If oven does not need to be adjusted, skip steps 7-9.
7. If adjustment is required, rotate oven downward. Using 2 or
more people, lift oven off of mounting plate, and set aside on a
protected surface.
8. Loosen mounting plate screws. Adjust mounting plate and
retighten screws.
9. Repeat steps 3-6.
10. With the oven centered, and with at least one person holding it
in place, insert bolts through upper cabinet into oven. Tighten
bolts until there is no gap between upper cabinet and oven.
NOTES:
• Some upper cabinets may require bolts longer or shorter than
3" (7.6 cm). Longer or shorter bolts are available at most
hardware stores.
Overtightening bolts may warp the top of the oven. To avoid
warping, wood filler blocks may be added. The blocks must
be the same thickness as the space between the upper
cabinet bottom and the oven.
m
w
D
A. Long tab (inside slot)
B. Damper assembly
C. Mounting screw
D. Upper cabinet cutout
2. Connect vent to damper assembly.
A B
A. Vent
B. Damper assembly (under vent)
11