Whirlpool GY395LXGQ3 Installation Instructions Manual
Whirlpool GY395LXGQ3 Installation Instructions Manual

Whirlpool GY395LXGQ3 Installation Instructions Manual

30" electric slide-in range

Advertisement

Quick Links

iati
i
e
Quick Reference
Table of Contents:
Pages
[]
[]
[]
[]
%-%
[]
[]
[]
[]
Before vou start
Product dimensions
Cabinet dimensions/requirements
Electrical
requirements
Installation
steps
Ufrange does not operate
Ufyou need assistance/service
if you need assistance:
Check your Use and Care Guide for a toll-free number to
call or call the dealer from whom you purchased this
appliance.The dealer is listed in theYellow Pages of your
Call when you:
[_ Have questions about range installation or operation.
[_ Need to obtain the name and number of an authorized
service company.
When you call, you wiii need:
[_ The range model number.
[_ The range serial number.
rating plate
located on the oven frame beMnd the storage drawer
panel.

Advertisement

Table of Contents
loading

Summary of Contents for Whirlpool GY395LXGQ3

  • Page 1: Table Of Contents

    iati Quick Reference Table of Contents: Pages Before vou start Product dimensions Cabinet dimensions/requirements Electrical requirements Installation steps Check operation Ufrange does not operate Ufyou need assistance/service Moving the range if you need assistance: Check your Use and Care Guide for a toll-free number to call or call the dealer from whom you purchased this appliance.The dealer is listed in theYellow Pages of your phone directory under "Appliances -- Household --...
  • Page 2 Cabinet opening dimensions that are Before you start,,, shown must be used. Given dimensions are minimum clearances. Your safety and the safety of Grounded electrical outlet is required. others are very important, level See "Electrical requirements/' Page 4. flat-blade screwdriver We have provided many important 3/8"...
  • Page 3 30-3/4" (78.1 cm) cooktop width (\ ../ 36" ( 91.4 cm: cooktop height with leveling legs lowered 1-1/2 turns 30" (76.2 cm) 26-7/8" width (6&2 cm) depth with "_ handle Cabinet opening dimensions shown are for: 25" countertop depth, 24" base cabinet depth, 36"...
  • Page 4 The cooktop sides of the slide-in range fit over the cutout edge of your countertop. (77.2 cm) if you have a square finish (fiat} countertop and the opening I/4" )pening width is 30-3/8" (77.2cm), no countertop preparation is (0.64 cm) required.
  • Page 5: Tip Over Hazard

    ow start... EJectricaJ connection Excessive Weight Hazard Use two or more peopb to move and ,'olmiJ / / install ramge. Tip Over Hazard Failure to do so can result in back or block cover A child or adult can tip the range other injury.
  • Page 6 NOTE: Thebagcontaining t hree to the center terminal screw on the easily attach the wiring to the terminal aluminum terminal l ugsis notused block. terminal block. See Figure 2, when connecting therange using a 11.Connect the other two wires (lines 1 5.
  • Page 7 NOTE:The bagcontaining t hree contact any other terminal. See aluminum terminal l ugsmustbeused Figure 2. whenmaking adirect w ireconnection. terminal 12. Loosen (do not remove) the 3 slotted screw set screws, insert the neutral (white) wire into the hob at the bottom of terminal _x'L_L_ set screw...
  • Page 8 Operating position M Move range close to cabinet opening. Remove cardboard or Place rack in oven. Place level hardboard from under range. Carefully on rack, first side to side; then front to move range into final position. back. If range is not level, pull range forward until rear leveling leg is removed from the anti-tip bracket.
  • Page 9: Check Operation

    Check operation Check the operation of the cooktop ebments: Push in and turn each surface unit controU knob to "HF position. Check the operation of the cooktop ebments and TIMER OVEN _]FF CLOCK LIGHT START TEMP COOKTIME DELAY STOPTI_E ENTER_ ( ANCEL BAKE BROIL...
  • Page 10: Moving The Range

    Moving the range: if range does not mfyou need serv|ce: operate; [_ Check that the circuit breaker is Maintain the quality built into your range not tripped or the house fuse by ca[ling an authorized service blown. company. To obtain the name and number of the [_ Check that the power suppUy cord is pUugged into the outlet.
  • Page 11 Notes...
  • Page 12: Part No. 9757849

    Part No. 9757849 @2003Whirlpool Corporation Benton Harbor, Michigan 49022 Printed in U.S.A.

Table of Contents