Power; To Detach The Battery Pack; Using The Battery Pack - JVC GR-DA30AA Instructions Manual

Charging The Battery Pack
1
Set the Power Switch to "OFF" (
2 2
Open the battery cover.
Press "w OPEN" and slide the battery
cover off the camcorder in the direction as
illustrated below.
3 3
Attach the battery pack.
With the "r" (arrow) on the battery pack
pointing at the correct direction, insert the
battery pack until it locks in place.
• Re-attach the battery cover. (For
BN-VF808U only)
AV
DC
4 4
Connect the AC adapter.
DC
connector
" "
• blinks to indicate charging has
started.
• When the lamp goes out, charging is
fi nished. Unplug the AC adapter from the
AC outlet and disconnect the AC adapter
from the camcorder.
GR-DA30AA_EN.indb 11 GR-DA30AA_EN.indb 11
9).
r Arrow
AC Adapter
To AC Outlet
(110V to 240V)
Getting Started

Power

To Detach The Battery Pack

Slide and hold BATT. (
battery pack.
Charging/recording time (approx.)
Battery pack
charging time
BN-VF808U
1hr. 30 min.
(Provided)
BN-VF815U 2 hrs. 40 min.
BN-VF823U 3 hrs. 50 min.
Notes:
• If a fully charged battery pack is attached to
" "
the unit,
seconds before it turns off.
• Since the AC adapter processes electricity
internally, it becomes warm during use. Be
sure to use it only in well-ventilated areas.
• After 5 minutes have elapsed in Record-
Standby mode with the cassette inserted and
no operation is performed, the camcorder
will automatically turn off its power supplied
from the AC adapter. In this case, the battery
charge starts if the battery is attached to the
camcorder.
• Please do not pull or bend the AC adapter plug
and cable. This may damage the AC adapter.

Using The Battery Pack

2
Perform steps –
Pack".
Notes:
• Recording time is reduced signifi cantly under
the following conditions:
• Zoom or Record-Standby mode is engaged
repeatedly.
• The playback mode is engaged repeatedly.
• Before extended use, it is recommended that
you prepare enough battery packs to cover 3
times the planned shooting time.
Attention:
Before detaching the power source, make sure
that the camcorder's power is turned off. Failure
to do so can result in a camcorder malfunction.
EN
9), then remove the
Maximum
Required Continuous
Recording
Time
1 hr. 55 min.
3 hrs. 45 min.
5 hrs. 40 min.
lamp will blink for approx. 10
3 3
in "Charging The Battery
7/9/2007 12:03:17 PM 7/9/2007 12:03:17 PM
11