Advertisement
_!__[c
Using the Air
Conditioner
NOTE: If air conditioner is turned off,
wait 3 minutes before restarting. This
allows pressure inside compressor to
equalize.
Failure to
follow
these
instructions
may cause inefficient
operation.
To reduce the risk of fire, electric shock, or injury to persons, read
the IMPORTANT SAFETYINSTRUCTIONSbefore operating this appliance.
To begin operating the air conditioner, follow these steps:
1. Plug in air conditioning unit. (To prevent electrical hazards, do not use extension
cord or adapter plug.)
2. Set exhaust vent to CLOSED position.
3. Set thermostat at highest number (coldest, or cooler setting).
4. Set Selector Control at highest cooling level (see below).
5. Adjust louvers for comfortable air flow.
6. Once room has cooled, adjust thermostat to setting you find most comfortable.
Review the "Air Conditioner Features" section for other settings.
Air Conditioner
Features
SELECTORSWITCH
The controls featured in this manual are representational
of the many models
available. Your model may offer slightly different features.
Selector
Control/Cooling
Units
The Selector Control turns unit on or off and allows a choice of either cooling room
air (COOL) or circulating room air at the existing temperature (FAN). The HI, LOW,
and on some models, MED settings determine the speed of air circulation.
FAN -- selection provides various levels of air circulation without cooling.
HIGH COOL--provides
maximum cooling and is recommended for cooling the
room quickly.
MED COOL -- (some models) -- fan runs slower, for moderate cooling needs.
LOW COOL -- fan runs slowly to maintain a comfortable cooling level.
Fan Only Operation
(Ventilating)
Turn the selector-switch knob to one of the following positions'.
HIGH FAN -- Maximum air circulation without cooling.
MED FAN -- Moderate air circulation without cooling.
LOW FAN -- Slow air circulation without cooling.
Selecting
the Temperature
_C_
The desired temperature
is selected by turning the temperature control
knob.
if temperature
in room is higher than desired, turn knob clockwise to a new
position, if the temperature is lower than desired, turn knob counterclockwise to a
new position.
Advertisement
