Air Flow Louvers Adjustments - Hitachi RAS-ME09HX1 Instruction Manual

AIR FLOW LOUVERS ADJUSTMENTS

1. Adjusting the left and right air Á ow directions
Move the vertical air Á ow louvers as illustrated,
to adjust the air Á ow to Á ow towards the left or
right directions.
2. Adjusting the downward air Á ow direction.
During the "Dehumidifying" or "Cooling" operating
modes, the horizontal air flow louvers are
automatically adjusted to suit the air Á ow angles
of each operating mode. The air Á ow louvers
are designed to direct air Á ow in upward and
downward directions. Pressing the automatic air
Á ow control button, these air Á ow louvers can
also be adjusted to any air Á ow angle of one's
choice.
Press the AUTOMATIC AIR FLOW DIRECTION
once will activate the horizontal air Á ow louvers
to direct the air Á ows upwards and downwards.
Press the control button again, the horizontal air
Á ow louvers will stop moving and remain À xed at
the position at the point when the control button
was pressed
During the "Dehumidifying" or "Cooling" operating
modes, set the horizontal air Á ow louvers to
move within the range as recommended in the
illustration
Adjusting the air Á ow louvers will direct air Á ows
to assist in reducing the room temperature and
to correct any temperature imbalance
During the "Cooling" operating mode, do not
adjust the horizontal air Á ow louvers to swing
outside the range as indicated by arrows in
the illustration. Do not operate the horizontal
air Á ow louvers in durations longer than it is
necessary. Condensate may form and drip along
the horizontal air Á ow louvers.
After stopping the operations of the unit by
pressing control button, the horizontal air
Á ow louvers will move to park at a position that
covers up the air outlet vent.
While the automatic air flow direction mode
is in operation, any physical adjustment to
the horizontal air flow louvers will shift the
swing range. However, with no further physical
adjustments, the air Á ow louvers will readjust
automatically to the original swing range setting.
(Should the louvers could not return to the original
swing range setting, stop the operation of the air
conditioner unit, remove the power supply plug
and re-plug it into the power mains socket and
restart the air conditioner unit. This will return
the swing range to its original setting)
– 13 –