NETGEAR XAVB1401 User Manual page 8

Connecting an XAV1401 to the Router
1. Plug an XAV1401 into a power outlet near your router.
Use the supplied gray Ethernet cable to connect from the XAV1401 to a LAN port on your
router so that the Powerline network can gain access to the Internet. The Power and
Ethernet LEDs on the XAV1401 should turn on.
Note: It is not necessary to disconnect your router from your computer.
Router
Figure 3. Connecting the XAV1401 to a Router
2. Once the Powerline adapter is plugged in and power is first applied, check to see that the
Power LED is on.
3. After approximately 10 seconds, check to see that:
a. The Power LED is solid green.
b. The Powerline LED is lit.
c. The Ethernet LED is on or blinks.
8 | Chapter 1. Installation and Basic Configuration
XAV1401 Powerline AV+ 200 Mini Set User Manual
Supplied Ethernet cable
XAVB1401
Laptop PC